User manual FUTUBA 12FG

[. . . ] 12FG 12 CHANNEL RADIO CONTROL SYSTEM PCMG3/PCM1024/FM selectable INSTRUCTION MANUAL Note: The battery in the T12FG transmitter is not connected to the battery connector at initial. Please connect the battery connector before use. 1M23N18902 TABLE OF CONTENTS INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] For safety, the throttle cut function operates the throttle stick in the 1/3 or less (slow side) position. 36 <Model Basic Setting Procedure> 5. Idle down setting The idling speed can be lowered with one touch by a switch without changing the throttle trim position. Perform this setting with the Idle Down function of the Linkage Menu. After activating the Idle Down function and selecting the switch, adjust the idle down speed. For safety, the idle down function acts only when the throttle stick is slow side. *While the Throttle Cut function is in operation, the Idle Down function does not work. The Condition Select function automatically allocates is the default condition and is the only one active when a p. 72. *The Condition 1 is always on, and remains on until other conditions are activated by switches. *When a new condition is added, the model data of the Condition 1 is automatically copied to the new condition. 6. AFR (D/R) AFR function is used to adjust the throw and operation curve of the stick, lever, and switch functions state. However, if the group mode (GROUP) was selected in advance, the same data will be input at all the conditions. For Group/Single mode switching, refer to the description at the back of this manual. maximum throw directions. *The Condition Delay can be programmed for each channel. The Condition Delay is used to change the servo throw smoothly when switching conditions. 9. When tailless wing model selected Tailless wing elevator operation uses elevator to camber mixing. This function cannot be performed at initial setting. 7. Airbrake This function is used when an air brake is necessary when taking off or diving, etc. The preset elevators and flaps (camber flap, brake servos can be adjusted as needed. Also the speed of the side/OUT side) A delay can be set for each condition, and a Cut switch which will turn OFF the delay can be chosen. Trim amounts can be fine-tuned by setting a VR. You can also set the Auto Mode, which will link Airbrake to a stick, switch, or dial. A separate stick <Model Basic Setting Procedure> 37 Helicopter basic setting procedure This section outlines examples of use of the helicopter functions of the T12FG. Model addition and call Default setting assigns 1 model to the T12FG. To add new models or to call a model already set, use the Model Select function of the Linkage Menu. available for helicopters. *For a description of the swash type selection, refer to the MODEL TYPE function, p. 51. 3. Flight condition addition The transmitter can install up to eight flight conditions per model. [. . . ] When the EDIT button is pressed, the ON/ OFF setting is changed. (Operate the EDIT dial or S1 button to stop the change. ) 4. To return to the preceeding screen, move the cursor to the [ON/OFF] at the top of the screen and push the EDIT button. 3. (Operate the EDIT dial or S1 button to stop the change. ) 4. [. . . ]