User manual FUTUBA FP-8SSHP

[. . . ] Futaba DIGITAL PROPORTIONAL RADIO CONTROL PCM SINGLE STICK PULSE CODE MODULATION SYSTEM D60421 Thank you for purchasing a Futaba digital proportional radio control set. Please read this manual carefully before using your set. When reading this manual, refer to the foldout at the end of this manual. CONTENTS FEATURES . 2 TRANSMITTER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30~31 SPLINED HORN AND FREQUENCY CHANNEL NO. [. . . ] The acceleration amount can be set to a maximum of amount 50% by turning this trimmer clockwise and to a minimum of 0% by turning this trimmer counterclockwise. Fig. This trimmer adjusts the idle up amount of the throttle servo when the idle up 2 switch [21] is set to ON. The idle up amount can be set as described in the idle up 2 switch [21] section on page 5 and in Fig. When the trimmer is turned counterclockwise, the idle up amount decreases. For a description of this trimmer, see the page 5 and Fig. When the trimmer is turned counterclockwise, the idle up point moves to the low side. Fig. 40 16 Revolution mixing compensation trimmer The revolution mixing (pitch control --> rudder mixing) can be set in the direction in which the mixing amount decreases as shown in Fig. 41 with this trimmer. Rudder servo Settable within this range by trimmer [16] . E. Elevator dual rate trimmer This trimmer adjusts the elevator servo throw when the elevator dual rate switch [15] is set to ON. It has the same functions as the aileron dual rate trimmer [1] described on page 13. 24. LINEAR <-> VTR This switch has the same functions as the aileron LINEAR <-> VTR switch [2] described on page 13. This switch is used to select aileron dual rate and elevator dual rate simultaneous ON-OFF or separate ONOFF. · When this switch is set to the lower position, the aileron dual rate switch [14] and elevator dual rate switch [15] can be turned on and off separately. ·When this switch is set to the COMB position, the aileron and elevator dual rates can be turned on and off simultaneously with the aileron dual rate switch [14]. Set it to the position you like best. Fig. This trimmer sets the rudder servo throw and direction when the rudder button [33] is set to ON (pressed). The servo throw can be adjusted up to the total travel. Rudder time trimmer This trimmer sets the time the rudder servo stops at a fixed deflection when the rudder button [33] is pressed. A time from 0 to about 3 seconds can be set. Rudder button fail safe switch When this switch is set to the RUD. REV position, the rudder button operates. When it is set to the INH side, the rudder button becomes inoperative. Fig. 2nd ATV ATV is the abbreviation of Adjustable Travel Volume. [. . . ] 65 1) The splined horn has 25 segments. The amount of change per segment is; 360 : 25 - 14. 4" 2) The minimum adjustable angle is determined by the number of arms or number of the holes in the shaft. For four arms, the minimum adjustable angle is: 360 : 25X4 =3. 6 Number of divisions To shift the holes center line "o the right (clockwise) relative to baseline A, shift arm 2 to the position of arm 1 and set it to the position closest to baseline A. the angular shift per segment is 14. 4° The s h i f t to the right is 90" - (14. 4 x 6) 3. 6° To shift the same angle in the opposite direction, use the opposite arm number. Fig. [. . . ]