User manual GAF EVERGUARD WB181 BONDING ADHESIVE MATERIAL SAFETY DATASHEET UPDATED 07-2010

[. . . ] 15 mg/m3 - total NE 7732-18-5 20 ­ 80 NE NE = Not Established SECTION 3: HAZARDS IDENTIFICATION PRIMARY ROUTE OF EXPOSURE: SIGNS & SYMPTOMS OF EXPOSURE EYES: SKIN: INGESTION: INHALATION: Eye contact may cause eye irritation. Prolonged or repeated skin contact may cause irritation. May cause gastrointestinal tract irritational if swallowed. [. . . ] Do not allow product to enter sewer or waterways. Keep unnecessary personnel away and upwind. Wear appropriate protective equipment and clothing during clean-up. SECTION 7: HANDLING AND STORAGE HANDLING AND STORAGE: For safe storage, store between 1 - 49 °C (34 - 120° F). Wear suitable protective clothing, safety glasses and gloves. Avoid contact with eyes, skin and clothing. Keep from freezing ­ product stability may be affected. Stir well before use. OTHER PRECAUTIONS: SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION ENGINEERING CONTROLS / VENTILATION: Work should be done in an adequately ventilated area. Local exhaust ventilation is recommended when general ventilation is not sufficient to control airborne contamination. Use NIOSH approved respirator if there is potential to exceed exposure limit(s). RESPIRATORY PROTECTION: Page 3 of 7 GAF Materials Corporation EYE PROTECTION: SKIN PROTECTION: MSDS # 2132 Safety goggles or safety glasses with side shields. Use impermeable gloves (Neoprene) and protective clothing as necessary to prevent skin contact. Eye washes and safety showers sould also be provided. Wash exposed skin prior to eating, drinking or smoking and at the end of each shift. Wash contaminated clothing prior to reuse. OTHER PROTECTIVE EQUIPMENT: WORK HYGIENIC PRACTICES: SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES APPEARANCE & ODOR: FLASH POINT: METHOD USED: EVAPORATION RATE: White milky liquid with a ammonia odor. Noncombustible No Data No Data LOWER EXPLOSIVE LIMIT: UPPER EXPLOSIVE LIMIT: BOILING POINT: No Data No Data 100 °C (212° F) water 0 °C (32° F) water 1. 1 (Water = 1) 20 ­ 80% water No Data pH (undiluted product): SOLUBILITY IN WATER: VAPOR DENSITY: VAPOR PRESSURE: 6. 5 - 11 Dilutable <1. 0 17 hPa at 20° C (68° F) No Data MELTING POINT: SPECIFIC GRAVITY: PERCENT VOLATILE: MOLECULAR WEIGHT: VOC WITH WATER (LBS/GAL): WITHOUT WATER (LBS/GAL): No Data SECTION 10: STABILITY AND REACTIVITY THERMAL STABILITY: CONDITIONS TO AVOID (STABILITY): INCOMPATIBILITY (MATERIAL TO AVOID): HAZARDOUS DECOMPOSITION OR BYPRODUCTS: HAZARDOUS POLYMERIZATION: STABLE X Freezing conditions. N/A UNSTABLE Thermal decomposition may yield acrylic monomers. Will not occur. Page 4 of 7 GAF Materials Corporation MSDS # 2132 _________________________________________________________________________________________ _ SECTION 11: TOXICOLOGICAL INFORMATION TOXICOLOGICAL INFORMATION: Acute Oral Toxicity Acute Dermal Toxicity Skin Irritation Eye Irritation LD50 rat > 5, 000mg/kg LD50 rat > 5, 000mg/kg Rabbit may cause transient irritation. Rabbit no eye irritation. SECTION 12: ECOLOGICAL INFORMATION ECOLOGICAL INFORMATION: No information available. _________________________________________________________________________________________ _ SECTION 13: DISPOSAL CONSIDERATIONS WASTE DISPOSAL METHOD: This product, as supplied, is not regulated as a hazardous waste by the U. S. [. . . ] Such information is to the best of our knowledge and belief accurate and reliable as of the date compiled. However, no representation, warranty or guarantee, expressed or implied, is made as to its accuracy, reliability, or completeness. It is the user's responsibility to satisfy himself as to the suitability and completeness of such information Page 6 of 7 GAF Materials Corporation MSDS # 2132 for his particular use. [. . . ]