User manual GAGGENAU AH590720

[. . . ] Operating and assembly instructions AH 590-720 Freely Suspended Insular Hood AH 590-720 Preface Safety notes 1. Important notes 1. 1 For your safety 1. 2 Operating for the first time 1. 3 About use 2. Maintenance Page 3 Page 4-5 Page 4 Page 5 Page 5 Page 6 Page 7-9 Page 10-11 Page 12 1 Preface With your new extractor hood, working in the kitchen will be even more fun. The appliance offers you a number of advantages: ­ a good extraction capacity with low noise level, ­ a large number of control functions, ­ optimum illumination of the cooking surface by a dimmable halogen light. [. . . ] the combination of the Int key and the key 2. or or Fig. 9 Delayed shut-off Delayed shut-off is possible at any level. First press the required key 1, 2, 3 or Int and then press the key (see Fig. The delayed shut-off time for all levels is ten minutes. After these ten minutes, the ventilation switches off, but the lighting stays on. or or or Fig. 11 or or Interval ventilation Interval ventilation is a special feature of this appliance which periodically activates the fan for five minutes every hour. You can activate this function by simultaneously pressing the 0 key and, depending on the required extraction capacity, the 1, 2 or 3 key (see Fig. This mode of operation is indicated by alternating illumination of the key together with the corresponding fan level indicator. You can switch off interval ventilation by pressing the 0 key (see Fig. Cleaning and care Cleaning the grease filters The grease filter saturation display F flashes after an operating time of 30 hours to indicate that you should clean the grease filters (see Fig. The grease filters can of course be cleaned at any time, even if the grease filter saturation display has not started to flash. The stainless steel grease filters can be removed easily for cleaning (see Fig. 13): Disconnect the power supply (switch off the fuse). Grip the grease filter handle and push the slide towards the rear. Then pull the grease filter downwards out of the holder; repeat the operation for the other grease filters. You can clean the stainless steel grease filters in a dishwasher at a maximum temperature of 150 °F / 65 °C, where it should be supported vertically to allow food or rinsing residues to drain off. If possible, the inner parts of the housing should be wiped out in hot rinsing water when replacing the filters. Caution: when cleaning the inside of the housing, beware of protruding parts. Fig. 13 After having cleaned them, re-insert the grease filters in the extractor hood in reverse order. Note: the handles of the grease filters must be visible after assembly. Fig. 14 Press the F key to set the elapsed hours counter to zero. Flashing of the indicating lamp goes off. 10 Cleaning the extractor hood Clean the extractor hood and the aluminiumdesign ventilation ducts (LK 590-011/021/031) with a soft cloth and mild detergent solution only. [. . . ] The marking "FRONT" must be on the same side as the control panel (Fig. Ventilation ducts LK 590-020/030/021/031 only: the enclosed extension module should be mounted on top of the support frame. Follow the above instructions for mounting the support frame and hood. Fig. Adjust the support frame to the desired height and secure with 8 screws. [. . . ]