User manual GAGGENAU CK482100

[. . . ] Operating and Assembly Instructions CK 481 CK 482 Electronic Glass-Ceramic Hob CK 481 CK 482 1. Important notes For your safety Operating for the first time About use 2. Features Features of the appliance Control panel Special accessories 3. Operation Switching on and off Residual heat display Memory function Energy saving tips Settings table 5. [. . . ] It is also possible to use the timer independently. The timer can also be used when the hob is switched off. Programming a switch-off time Programming a switch-off time · Set the cooking zone which you want to time to the required cooking level. Select the required time using the UP-/DOWN-symbols. · The value is confirmed a few seconds later by an audible signal and the timer starts. Alternatively you can confirm the values by again touching the timer symbol in the control panel. · Touch the cooking zone in the display panel which you would like to timer operate. The display flashes the selected cooking level. · A spot appears next to the cooking level on the cooking zone display. The timer is now set for this cooking zone. · After the elapse of the programmed time an audible signal is sounded. The selected cooking zone is switched off. Both the selected cooking value and the timer flash. By touching any symbol on the display the audible signal is switched off and the cooking zone display shows zero. 15 Timer operation Changing or erasing a given time value · Touch the timer symbol. · You can now change the programmed time using the UP-/DOWN-symbols. Touch the UP-/DOWNsymbols simultaneously or touch the DOWNsymbol, until 00 shows on the display. The spot on the cooking zone display disappears. The cooking zone remains on the selected cooking level without timer operation. Programming the timer without cooking zone switch-off Programming the timer without cooking zone switch-off It is also possible to use the timer independently from the cooking zones and without switch-off function. Any value between 1 and 90 minutes can be entered on the timer. Select the required time using the UP-/DOWN-symbols. · The value is confirmed a few seconds later by an audible signal and the timer starts. Alternatively you can confirm the values by again touching the timer symbol in the control panel. · The timer display shows the elapsed time. [. . . ] Do not tighten the clamping screws too tightly, as a uniform sealing gap should be left all round. · Connect the appliance to the electricity. Check the appliance works correctly. Removal of the hob Disconnect the appliance from the electricity. Carefully push out the appliance by the metal base from below. [. . . ]