User manual GAGGENAU VF230610

[. . . ] Operating and assembly instructions VF 230-610 Electric deep fryer 0 380 0 360 340 320 VF 230-610 Preface Important safeguards 1. Important notes 1. 1 For your safety 1. 2 Operating for the first time 1. 3 About use 2. Structure and operating principle 2. 1 Structure of the appliance 2. 2 Accessories 2. 3 Operating principle 3. Operation 3. 1 Switching on/off 3. 2 Fat melting stage 3. 3 And this is how to deep fry 3. 4 Operating the child lock 4. [. . . ] ­ When the food is ready (see Table 7. 1), take out the deep frying basket and shake it lightly. This will make sure that the fat or oil can drip of faster. Note: The deep frying times stated are only approximate values; more or less times and energy may be required, depending on the condition of the food and your own personal taste. Do not salt or spice the food above the deep fryer, since this would flavour the oil or fat and, consequently, the next food fried. 320 340 0 380 0 360 340 320 Fig. 13 360 Please observe our tips and tricks!10 3. 4 Operating the child lock Activating the child lock ­ Turn the "Short time" control knob to the left to the minus position. Hold the knob in this position. 0 380 0 ­ Turn the "Temperature" control knob to any temperature on the right. 320 360 340 ­ Turn the "Temperature" control knob back to the 0 position. ­ Turn the "Short time" knob back to the 0 position. The symbol (child lock) flashes on the display (Fig. You can now turn the "Temperature" control knob to any position without the appliance heating up. Fig. 14 Deactivating the child lock ­ Turn the "Short time" control knob to the left to the minus position and hold the knob in this position. 0 380 0 ­ Turn the "Temperature" control knob to any temperature on the right. 320 360 340 ­ Turn the "Short time" control knob to the 0 position. ­ Turn the "Temperature" control knob to the 0 position. The "child lock" symbol on the display goes off (Fig. The appliance is now operable again. Fig. Cleaning and care Please clean the appliance thoroughly before operating it for the first time. Cleaning the deep frying tub: ­ Take out the deep frying basket and tilt up the heating element. Clamp the heating element onto the deep frying basket suspension (Fig. ­ Pour approximately four litres of water with detergent into the empty tub. ­ Tilt the heating element back into the frying tub and heat up the appliance to the fat melting stage. ­ The water is drained off through the oil drain valve, which is located under the funnel-shaped base of the deep frying tub as follows: Unscrew the plastic cap from the drain valve and open the oil drain valve by turning the handle down (Fig. ­ Use a temperature-resistant bucket with a capacity of at least 10 litres to collect the water. ­ Rinse the appliance with hot water and rub it dry. [. . . ] The mains connecting cable must at least correspond to the type SJTO 3x16 AWG 105°C (oil resisting). You are advised to install a socket outlet earthed in accordance with regulations approximately 70 cm (271/2") above the floor behind the appliance. This must still be accessible after installation. If damaged, the mains cable must be replaced by a special mains connecting cable. [. . . ]