User manual GAGGENAU VG232232CH

[. . . ] Operating and assembly instructions VG 232 Gas cooker VG 232 Preface 1. Important notes Page 3-4 1. 1 For your safety Page 3 1. 2 Operating for the first time Page 3 1. 3 About use Page 4 2. Structure and operating principle Page 5-6 2. 1 Structure Page 5 2. 2 Special accessories Page 5 2. 3 Operating principle Page 6 3. Maintenance Page 9 5. 1 General Page 9 5. 2 Remedying slight malfunctions yourself Page 9 6. [. . . ] Switching on: ­ Place a pot or a pan on the corresponding cooking position. ­ Fully press in the control knob for the corresponding cooking position. ­ Turn the control knob to the left to the "high" position. If the flame should not ignite within 2 to 4 seconds, turn the control knob further to the left to the "low" position and then back to the "high" position after ignition. It is often faster to ignite in the low position because the various gases have a differing ignition response. After igniting, keep the control knob pressed for around 5 - 8 seconds more because the heat sensor that opens the gas channel has to warm up first. Repeat the operation if the flame should go out again. The flame size can be set continuously between full and low by slowing turning the control knob. Switching off: Fully turn the control knob to the left to the 0 position on the left. Fig. Cleaning and care Please thoroughly clean the appliance before operating it for the first time and after every use. ­ Wait until the appliance has cooled down. ­ Clean the hob, the burner covers and the pot grid with commercially available cleaning agents (not in a dishwasher!), e. g. with warm soap solution and a dishwashing brush. ­ Whenever required, clean the burner head with a moist cloth. ­ Soak burnt-in remainders in a little water and detergent. This loosens even the most stubborn of soiling. Do not use any abrasive agents and abrasive sponges. ­ As the result of heat development, slight discoloration can appear on the stainless steel surface. Do not attempt to scrape away such discoloration. Distribute stainless steel care agents uniformly and thinly on the hob (not on the control panel!). This will ensure an even surface and will keep your hob in a good condition for a long period of time. Important: Allow the burner covers to cool down before cleaning them! [. . . ] If it should be necessary to correct the low-setting nozzle 1 as the result of deviating gas types and pressure, the flow rate can be increased by turning to the left. Fig. 8 14 Replacing the main nozzle 2 Proceed as follows: ­ The main nozzle 2 is visible after detaching the burner cover (see Fig. It is unscrewed with a special screw key. ­ Unscrew the nozzle and insert the new nozzle as specified in the main nozzle table. [. . . ]