User manual GAGGENAU VL431107

[. . . ] And now we wish you lots of fun with your new hob ventilator. VL 430 2 1. Important notes For your safety Do not operate the appliance if it is damaged. The appliance must only be connected by an authorised specialist, paying attention to the relevant regulations of the power supply companies and the regional construction regulations. Make sure that connecting cables do not come into contact with hot cooking surfaces. [. . . ] The indicator light of the chosen level lights. 1 = Low speed, the flaps open 2 = High speed = Approximately 20 minutes run-on time on level 1. Then, the hob ventilator switches off automatically and the flaps shut. Ideal for ventilating the kitchen after cooking. Switching off Press the 0 membrane key. Cleaning and care The grease filters must be cleaned on a regular basis (at the latest after 30 hours of operation). Cleaning the grease filter · Switch appliance to level 1. · Push the flaps towards the front and carefully lift them up on the rear. · Turn the two retaining hooks on the sides up, slightly push them together and remove the metal grease filter. You can clean the metal grease filter in a dishwasher at a maximum temperature of 55 °C. Place the grease filter in the dishwasher with the opening pointing down to ensure that no food remainders will stay on it. Insert in the reverse order as follows: switch appliance to level 1. Insert the grease filter and turn the two retaining hooks down. Insert the flap pins on the front into the hole and hook in at the rear at the correct angle. Cleaning the flaps Do not clean the flaps in a dishwasher. Cleaning the frame and the membrane key pad Apply commercially available window cleaning agent with a soft, moist cloth. Note: do not use any strong, caustic or abrasive cleaning agents. Do not use any abrasive sponges or brushes either. 7 5. Assembly instructions Important notes on installation The appliance must only be connected by an authorised specialist. The specialist is responsible for perfect functioning of the appliance at its installation location. He must explain to the user how the appliance can be disconnected from the mains whenever required. The exhaust air can be routed into a separate exhaust air shaft or directly into the open through the outside wall. It is not allowed to pass the exhaust air into a flue or exhaust air chimney that is in operation or into a shaft that is linked to the heating basement. [. . . ] · Connect the appliance to the fan module by means of a flexible aluminium pipe with a diameter of 125 mm. · Connect the appliance to the fan module by means of the 4-pole plug. We recommend the use of our telescopic wall box TM 180-043 to route exhaust air through the outside wall. Installing the edge trim AL 400-000 The edge trim has to be fitted to the side of the hob ventilator, if this ventilator is installed together with other Vario appliances and forms the left or right edge of this combination. [. . . ]