User manual GAGGENAU VR230934

[. . . ] Safety during use can only be ensured if the appliance is fitted correctly according to these installation instructions. The installer is responsible for ensuring that the appliance operates perfectly at the point of installation. The appliance must be connected to the mains only by a licensed and trained technician. Before carrying out any type of work, turn off the electricity. [. . . ] Tighten the retaining screws on the hinge. Check if it rests evenly on the appliance. If necessary, align the appliance cover after loosening the screws on the securing brackets. Tighten the screws. The surrounding kitchen unit must be heat-resistant to at least 90 °C. The stability of the unit must be maintained after producing the cut-out. Produce the cut-out for one or several Vario appliances. Proceed as shown in the installation sketch. The angle between the cut surface and the worktop must be 90°. After producing the cut-out, remove the shavings. Seal the cut surfaces to make them heat-resistant. Observe a minimum clearance between the appliance housing and parts of the unit of 10 mm. Protection against accidental contact from below must be guaranteed after installation. If the underside of the appliance can be touched after installation, an intermediate shelf must be fitted that can only be removed using a tool. Observe a minimum clearance between the appliance and the shelf of 10 mm. When fitting several Vario appliances: allow for the additional space required for the connecting strip VV 200. Appliances can also be fitted in individual recesses, if a minimum clearance of 40 mm between the appliances is observed. Special instructions for installation outdoors Do not use charcoal or similar combustible fuels with this appliance. Operate the appliance on a residual current device (RCD) with a maximum tripping current of 30 mA. Attach a suitable plug for outdoor use to the mains cable (observe the respective national regulations). Connect the appliance to an earthed socket (for protection class I appliances). Check the mains cable regularly for signs of damage. [. . . ] Only a qualified electrician who takes the appropriate regulations into account may connect a socket. Only connect the appliance with the supplied mains connection cable. Do not kink or trap the mains connection cable. The appliance corresponds to type Y: the mains connection cable must only be replaced by the after-sales service. [. . . ]