User manual GALLIEN-KRUEGER 200MK

[. . . ] The 200MK/RK features treble and bass controls on each channel as well as chorus and echo. The 200MK/RK also features direct outs and a monitor in for use in the studio and for live performances. A careful examination of this manual will help you to get the most from all the special features this amplifier offers. [. . . ] Phones The phones jack is also a ¼'' Stereo jack. It delivers a stereo signal for use with high impedance headphones (600 ohms or greater). Plugging into the headphones jack does not disconnect the internal speaker. To disconnect the internal speaker use speaker on/off switch on rear panel. Line Out The direct line level out serves two functions in the 200MK/RK. When in stereo (see mono/stereo switch) the line out acts as the right side line out for use with the 200MP powered monitor. When in mono the line out is a regular balanced line out. Mono/Stereo Switch The mono/stereo switch will change the line out and direct outs from mono to stereo. This also changes the headphones jack from mono to stereo. Monitor In This jack allows the input of a monitor send to come in and be heard through the internal speaker but not through the line out or direct outs. Direct Out Right/Left Two low impedance direct outs are provided for recording or live performances. When operating in stereo the direct outs are left and right. When in mono mode both directs are mono. Int/Ext Speaker Switch This switch allows the player to turn off the internal speaker for headphones use or for exclusive extension speaker use. Ext Speaker Jack This jack is a standard ¼'' jack for the addition of an external speaker. With the internal speaker on, an 8ohm load can be added and with internal speaker off, a 4 ohm load can be added. [. . . ] Your amp can be serviced at any GK authorized service center or at the GK factory if needed. Accessories Effects Footswitch; Stereo Cord; Road Bag (MK, RK) 200MP MIC Stand Kit (MK); Rack Mount Kit(RK) 2 200MK 200RK 200MK Block Diagram 200MK & 200RK Specifications Power@400Hz :100watts into 4ohms at 1%THD :65watts into 8ohms at 1%THD Signal-to-noise ratio :>80db Max Distortion :w/Limiter 35% Frequency Response :<±1db 20-20khz Tone Controls : :±15db at 10khz :±15db at 80khz Instrument Inputs :Max input level 1. 5v rms :Input impedance 1M ohms :Input sensitivity 150mv rms Monitor Input :Input impedance 100K ohms :Monitor in sens. . 5v rms Direct Out :-25dbm(nom) Dimensions 200MK 200RK Weight 24lbs. [. . . ]