User manual GAMES PS2 SOULCALIBUR III

[. . . ] Refer servicing to qualified personnel only. For use only with power supply GAMES PS2, Model HDAC-M1. Disclaimer Sony Corporation assumes no responsibility for the loss of information stored on the hard disk of this unit, or information transferred to a "Memory Stick" and/or CompactFlash card with your computer. Caution This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] · Other system and product names used herein are registered trademarks or trademarks of their respective manufacturers, although the TM and ® marks are not used in the text. In this document, Microsoft® Windows® XP Professional and Microsoft® Windows® XP Home Edition are referred to as Windows XP. In this document, Microsoft® Windows® 2000 Professional is referred to as Windows 2000. In this document, Microsoft® Windows® Millennium Edition is referred to as Windows Me. 4 Introduction Thank you for purchasing the HDD Photo Storage SOULCALIBUR III. This document explains how to prepare your unit for use. For details about how to use the unit, refer to the operating instructions in PDF format on the hard disk of the unit. To locate the operating instructions, refer to "ReadMe. html" on the internal hard disk of the unit. Accessories When you unpack the unit, make sure that all the items listed below are present. If anything is missing, contact your dealer or an authorized service center in your area. · HDD Photo Storage unit (1) · USB cable (1) OPE N · AC power adapter (1) (GAMES PS2, Model HDAC-M1) · Power cord (1) · Carrying case (1) · Hand strap (1) · Operating Instructions (on the hard disk) · PhotoDiary software (on the hard disk) · Read Me First (this document) (1) · Warranty card (1) 5 What you can do with the HDD Photo Storage Store images from a digital camera!Simply take pictures, and then insert the media into the HDD Photo Storage to copy the image data to the internal hard disk. After copying, you can reuse the media immediately. Insert it in the v direction all the way into the slot. Notes · An error message appears on the display when an error has occurred. For details, see "Error Messages" in the HDD Photo Storage Operating Instructions (PDF). · When the unit is used stand-alone, it is not possible to insert both a "Memory Stick" and CompactFlash card, and copy data from both at the same time. Insert one media at a time. 3 Press COPY. CANCEL A folder is automatically created on the internal hard disk and the data is copied to the folder. While copying is in progress, the copy progress bar shows the copying status. When copying is done, "COMPLETED" (copy completed) appears on the unit display. Copy progress bar Number of folders copied Number of files copied Number of folders to be copied Number of files to be copied Note If the error message "HDD Disk Full" appears, the remaining space on the internal hard disk is insufficient to finish copying. Connect the unit to a computer and use the computer to delete unnecessary data on the internal hard disk of the unit. For details, see "Deleting unnecessary files and folders" in the HDD Photo Storage Operating Instructions (PDF). 10 4 Remove the media. Push in Release briefly and pull out Push in fully Pull out 11 Viewing data on the internal hard disk using a computer Preparing the HDD Photo Storage and computer This section describes how to connect the unit to a computer using the USB cable to transfer data between the two devices. Hints · When the unit is connected to a computer, you can insert a "Memory Stick" and a CompactFlash card at the same time and access data from both. · When the unit is connected to a computer for the first time, the necessary programs are installed automatically. 1 2 Turn on the computer. (power) button The "Welcome to GAMES PS2 HDPS" appears on the unit display. 3 Open the port cover on the right side of the unit and connect the supplied USB cable to the (USB) port. Connect the other end of the cable to the USB port of your computer. 1 To the (USB) port 2 To the USB port of your computer To the AC outlet Note Correct operation is not guaranteed when the unit is connected to a USB hub. [. . . ] As the number of indicator bars decreases, less charge remains. Indicator Remaining battery capacity Description 75% ~ 100% 50% ~ 75% 25% ~ 50% 10% ~ 25% 0% ~ 10% Connect the AC power adapter to charge the internal battery. The remaining battery charge is getting low, but is still sufficient to copy several more media. c Connect the AC power adapter and fully charge the battery. For details, see "Charging the battery" (page 8). [. . . ]