User manual GARDENA 300

[. . . ] For Your Safety Checks before each operation : Before use, an inspection is always to be performed In order to determine that all nuts, bolts and working tools are not worn down or damaged. Worn down or damaged blades are to be replaced in sets. Inspect the surface on which the lawn mower is to be used be-forehand. Stones, pieces of wood and wires as well as other solid matter are to be removed. [. . . ] Unhook upright and clean cylinder mower. Check cylinder 9 and lower blade 0 for notches and remove these with a grindstone if necessary. 9 8 A 0 3. Unscrew internal hexagon screws A with an internal hexagon wrench (5 mm) anticlockwise until the cylinder 0 turns freely. Push the feeler gauge supplied (thin strip of metal) 8 between one blade 9 on the cylinder and the lower blade 5. Tighten left internal hexagon screw A with an internal hexagon wrench (5 mm) until the feeler gauge 8 is held gently. Continue turning the cylinder until the blade 9, already adjusted on the left side, is exactly above the lower blade on the right side. 0. 0 7. Tighten the right internal hexagon screw A with an internal hexagon wrench (5 mm) until the feeler gauge 8 is held gently. If a banging noise is produced during this, open up the internal hexagon screw A slightly on the side affected. When the cylinder and the lower blade can hardly be heard touching each other, the cutting mechanism has been adjusted correctly. Cutting test : Place a strip of paper B in such a way on the lower blade that it points towards the spindle of the cylinder 9. If the lower blade is set correctly as if with scissors. 9 B 0 0 0 the paper will be cut off 9. 11. Repeat the cutting test on the other blades 11 GB Regrinding / repairs : A On safety grounds, only original GARDENA spares may be used. Please contact GARDENA Service if it is necessary to replace the cutting tool, which will only become blunt after several years use if well-maintained. Repairs to the cylinder mower and the installation of the blades can be undertaken by suitable specialist workshops. Have the cylinder mower checked over in the autumn if possible so that it is ready for use immediately when the next lawn-mowing season starts. If you have any problem with your cylinder mower, please contact our Customer Service. GB 8. Accessories GARDENA Grass collecting bag Saves raking up the cut grass. Art. 4020) Cutting width / Cutting height Cutting height adjustment Weight 30 cm / 12 - 42 mm infinitely variable 8. 0 kg 380 (Art. 4023) 38 cm / 12 - 42 mm infinitely variable 8. 5 kg 10. Warranty GARDENA guarantees this product for 2 years (starting from the date of purchase). This guarantee covers all serious defects of the unit that can be proved to be material or manufacturing faults. Under warranty we will either replace the unit or repair it free of charge if the following conditions apply: · The unit must have been handled properly and in keeping with the requirements of the operating instructions. · Neither the purchaser or a non-authorised third party have attempted to repair the unit. [. . . ] 32 . : (+ 7) 495 380 31 92 info@gardena-rus. ru Singapore Hy- Ray PRIVATE LIMITED 40 Jalan Pemimpin # 02-08 Tat Ann Building Singapore 577185 Phone: (+ 65) 6253 2277 shiying@hyray. com. sg Slovak Republic GARDENA spol. Tuanka 115 627 00 Brno Phone: (+ 420) 548 217 777 gardena@gardenabrno. cz Slovenia GARDENA d. o. o. Brodie 15 1236 Trzin Phone: (+ 386) 1 580 93 32 servis@gardena. si South Africa GARDENA South Africa (Pty. ) Ltd. Box 11534 Vorna Valley 1686 Phone: (+ 27) 11 315 02 23 sales@gardena. co. za Spain GARDENA IBÉRICA S. L. U. [. . . ]