User manual GARDENA 858

[. . . ] If the battery goes dead, you will have to re-configure watch settings after recharging. To ensure normal watch operation, be sure to keep it exposed to light as much as possible. Battery charges in the light. Solar cell (Converts light to electrical power. ) Applications The built-in sensors of this watch measure direction, barometric pressure, temperature and altitude. Measured values are then shown on the display. Such features make this watch useful when hiking, mountain climbing, or when engaging in other such outdoor activities. [. . . ] · After calculation is complete, the Moon information (Moon age and phase) and tide information (current tide level and tide range) will be displayed for the date you selected. Measurement date (Month ­ Day) Measurement time (Hour : Minute) 2. While the Moon information (Moon age and phase) and tide information (tide level and tide range for the current date) are displayed, you can press B (+) to advance the displayed tide range by one hour. · You also can use A (+) and C (­) to change the date. · Update of the Moon Phase indicator and the Tide Graph is stopped while any of the following is occurring. During button operation While an alarm is sounding While a countdown beeper is sounding During display illumination During a 2-hour barometric pressure reading operation 1. In the Data Recall Mode, hold down E until CLR flashes on the display and the watch beeps twice. · Releasing E at any time while CLR is flashing on the display will cancel the delete operation. · The watch will beep to indicate that all of the altitude data stored in watch memory (including readings you stored and the high altitude value) is deleted. L Adjusting the High Tide Time Use the following procedure to adjust the high tide time within a particular date. You can find out high tide information for your area from a tide table, the Internet, or your local newspaper. To adjust the high tide time 1. In the Tide/Moon Data Mode, use A (+) and C (­) to select the date you want. · After you select a date, the watch starts to calculate Moon and tide data for the date you selected. · Northerly view: Moon is north of you. · Southerly view: Moon is south of you. When the Moon phase indicator setting is the way you want, press E to exit the switching screen and return to the Tide/Moon Data Mode screen. l l lll l l lll l l llll 3. When the setting you want to change is flashing, use A and C to change it as described below. Setting Start Time Screen Button Operations Use A (+) and C (­) to change the setting. · You can set a start time in the range of 1 to 60 minutes in 1-minute increments. Use A (+) and C (­) to change the setting. · You can set a reset time in the range of 1 to 5 minutes in 1-minute increments. Countdown Timer Seconds Minutes Current time The countdown timer can be set within a range of one minute to 60 minutes. An alarm sounds when the timer reaches zero. The press of a button will start the countdown timer from the currently set start time, and a progress beeper sounds to keep you informed of the current status of the countdown. These features make it possible to use the watch for yacht racing. [. . . ] It takes approximately 20 to 30 minutes for the case of the watch to reach the actual surrounding temperature. Pressure Sensor and Temperature Sensor Calibration The pressure sensor and temperature sensor built into the watch are calibrated at the factory and normally require no further adjustment. If you notice serious errors in the pressure readings and temperature readings produced by the watch, you can calibrate the sensor to correct the errors. · Incorrectly calibrating the barometric pressure sensor can result in incorrect readings. Before performing the calibration procedure, compare the readings produced by the watch with those of another reliable and accurate barometer. [. . . ]