User manual GARMIN EDGE 500

[. . . ] owner's manual GPS-ENABLED CYCLING COMPUTER EDGE® 500 © 2009 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, USA Tel. (913) 397. 8200 or (800) 800. 1020 Fax (913) 397. 8282 Garmin (Europe) Ltd. [. . . ] Attach the pedal magnet to the crank arm using the adhesive mount and a cable tie. The pedal magnet must be within 5 mm of the GSC 10. The indication line on the pedal magnet must line up with the indication line on the GSC 10. 4. Unscrew the spoke magnet from the plastic piece. Place the spoke in the groove of the plastic piece and tighten slightly. The spoke magnet can face away from the GSC 10 if there is not enough room between the sensor arm and the spoke. The spoke magnet must line up with the indication line on the sensor arm. Edge 500 Owner's Manual ANT+ Sensors Sensor arm indication line Spoke magnet GSC 0 Pedal magnet GSC 10 and Magnet Alignment 6. Move the sensor arm to within 5 mm of the spoke magnet. You can also tilt the GSC 10 closer to either magnet for improved alignment. 8. The red LED blinks each time the pedal magnet passes the sensor. The green LED blinks each time the spoke magnet passes the sensor arm. NOTE: The LED blinks for the first 60 passes after a reset. Press Reset again if you require additional passes. When everything is aligned and working correctly, tighten the cable ties, the sensor arm, and the spoke magnet. Edge 500 Owner's Manual 5 ANT+ Sensors 1. Bring the Edge within range (3 m) of the GSC 10. Select Settings > Bike Settings > [Bike 1] > ANT+ Spd/Cad. When the GSC 10 is paired, a message appears and the cadence icon appears on the main menu. Customize optional data fields (page 35). Go for a ride. Using the GSC 10 About the GSC 10 Cadence data from the GSC 10 is always recorded. If there is no GSC 10 paired, GPS data is used to calculate the speed and distance. Cadence is your rate of pedaling or "spinning" measured by the number of revolutions of the crank arm per minute (rpm). There are two sensors on the GSC 10: one for cadence and one for speed. [. . . ] Press and hold POwEr and rESET until the message appears. NOTE: This deletes all user-entered information including history. Take your Edge out of parking garages and away from tall buildings and trees. Allow the Edge battery to fully discharge, and then fully charge the battery (without interrupting the charge cycle). [. . . ]