User manual GARMIN FISHFINDER 140

[. . . ] Fishfinder 90/140 ® owner's manual © 2006 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. 913/397. 8200 or 800/800. 1020 Fax 913/397. 8282 Garmin (Europe) Ltd. [. . . ] Secure the tilt mount bracket or swivel base with three bolts or screws. If you are using the swivel mount, place the swivel mount bracket over the swivel base and secure it with the short knob. Swivel mount bracket To mount the bracket assembly: Swivel base (Fishfinder 90) (Fishfinder 140; Fishfinder 90 option) Fishfinder 90/140 Owner's Manual 9 INSTALLING YOUR FISHFINDER Installing the Unit on the Mount Bracket 1. Align the slot on the back of the Fishfinder with the long mounting knob, and slide the Fishfinder into place. If necessary, adjust the long knob to spread the bracket arms apart. (Turn counter-clockwise to widen the bracket arms and clockwise to tighten. ) 2. Adjust the Fishfinder angle, and tighten the long mounting knob until snug. For the Fishfinder 140 (Fishfinder 90 option), rotate the swivel mount bracket by twisting it left or right. Select a good viewing angle, and then tighten all knobs. To install the Fishfinder on the mount bracket: Installing the Wiring Harness The Fishfinder comes with a wiring harness that connects the Fishfinder to power and the transducer with one easyto-remove connection. If it is necessary to extend the power wires, use 22 AWG wire. DO NOT cut the transducer cable, because this voids your warranty. If your boat has an electrical system, you might be able to wire the Fishfinder directly to an unused holder on your current fuse block. If you are using the boat's fuse block, remove the in-line fuse holder supplied with the Fishfinder. You can also wire the Fishfinder directly to the battery. CAUTION: The Fishfinder input voltage is 10­18 volts DC. Do not exceed this voltage, because this can damage the Fishfinder and void the warranty. To install the wiring harness: 1. Determine the polarity of the power source using a test light or volt meter. Install the red (+) wire on the positive fuse holder or battery terminal. 10 Fishfinder 90/140 Owner's Manual INSTALLING YOUR FISHFINDER 3. Install the black (-) wire on the negative fuse holder or battery terminal. Install a 2 Amp fuse in the fuse holder (fuse block only). Align the notches on the cable plug and on the back of the Fishfinder. Insert the cable into the connector and turn the lock ring counter-clockwise until it stops. Begin testing the installation at a slow speed. [. . . ] Garmin retains the exclusive right to repair or replace the unit or software or offer a full refund of the purchase price at its sole discretion. SUCH REMEDY SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY FOR ANY BREACH OF WARRANTY. To obtain warranty service, contact your local Garmin authorized dealer or call Garmin Product Support for shipping instructions and an RMA tracking number. The unit should be securely packed with the tracking number clearly written on the outside of the package. [. . . ]