User manual GARMIN G1000 COLUMBIA PILOTS GUIDE

[. . . ] Columbia 350/400 Copyright © 2006 Garmin Ltd. This manual reflects the operation of System Software version 530. 01 or later for the Columbia 400 and 530. 02 or later for the Columbia 350. Some differences in operation may be observed when comparing the information in this manual to earlier or later software versions. Garmin International, Inc. , 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. [. . . ] If navigating a flight plan previous to loading this approach, the G1000 will continue navigating the flight plan until the approach is activated. 9) Press the ENT Key to activate the approach and begin navigating to the IAP. 10) If the approach is not approved for GPS, a `NOT APPROVED FOR GPS' messages is displayed with `YES' highlighted. Press the ENT Key to acknowledge the message (or select `NO'). 11) Press the ENT Key to return to the Approach Loading Page. MENU OPERATIONS Figure 5-52 Nearest Airport Page Menu Accessing information for a specific airport: 1) With the Nearest Airports Page displayed, press the MENU Key (Figure 5-52). 2) Select `Select Airport Window' and press the ENT Key. The cursor is placed in the `NEAREST AIRPORTS' field. 4) Press the FMS Knob to remove the flashing cursor. 190-00552-00 Rev. A Garmin G1000 Pilot's Guide for the Columbia 350/400 5-81 GPS NAVIGATION Accessing runway information for the selected airport: 1) With the Nearest Airports Page displayed, press the MENU Key. 2) Select `Select Runway Window' and press the ENT Key. The cursor is placed in the `RUNWAYS' field. 4) Press the FMS Knob to remove the flashing cursor. Quickly tuning the COM transceiver to a nearby airport frequency: 1) With the Nearest Airports Page displayed, press the MENU Key. 2) Select `Select Frequency Window' and press the ENT Key. The cursor is placed in the `FREQUENCIES' field 3) Turn the FMS Knob to select the desired frequency. The selected frequency is placed in the COM standby frequency tuning box. 5) Press the Frequency Transfer Key to place the frequency in the active field. 6) Press the FMS Knob to remove the flashing cursor. Selecting and Loading an approach from the Nearest Airports Page: 1) With the Nearest Airports Page displayed, press the MENU Key. 2) Select `Select Approach Window' and press the ENT Key. The cursor is placed in the `APPROACHES' field. The LD APR (load approach) Softkey becomes available. The Approach Loading Page is displayed with the transitions field highlighted. 7) Press the ENT Key to load the approach. [. . . ] Because of this, the surveillance information is approximately five seconds old. TIS ground station tracking software uses prediction algorithms to compensate for this delay. These algorithms use track history data to calculate expected intruder positions consistent with the time of display. Occasionally, aircraft maneuvering may cause variations in this calculation and create slight errors on the Traffic Map Page. [. . . ]