User manual GARMIN G1000 DIAMOND COCKPIT REFERENCE GUIDE DA40ANDDA40FSOFTWAREVERSION0369.09ORLATER,DA40D0370.13

[. . . ] G1000 TM Cockpit Reference Guide for the Diamond DA40 Copyright © 2004, 2005 Garmin Ltd. This manual reflects the operation of System Software version 0369. 09 or later for the Diamond DA40, DA40F, and System Software version 0370. 13 or later for the Diamond DA40D. Some differences in operation may be observed when comparing the information in this manual to earlier or later software versions. Garmin International, Inc. , 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. [. . . ] Press the FMS knob to activate the cursor. Turn the large FMS knob to scroll through the list, highlighting the desired airspace. Press the ALERTS softkey and turn either FMS knob to select the desired airspace. Press the FMS knob to remove the flashing cursor. 7. 14 NEAREST AIRSPACES View and Quickly Load the Frequency for a Controlling Agency 1. 2. Figure 7-16 Nearest Airspaces Page Select the Nearest Airspaces Page. Press the FREQ softkey and turn either FMS knob to select the desired frequency. Press the ENT key to load the frequency into the `COM' frequency standby field. Select the Nearest Airspaces Page 1. Turn the large FMS knob to select the NRST page group. Turn the small FMS knob to select the seventh rectangular page icon. Airspace Alerts Box · If the projected course takes the aircraft inside an airspace within the next ten minutes, `Ahead' is Garmin G1000 Cockpit Reference Guide for the DA40 7-9 SECTION 7 ­ NAVIGATION This page intentionally left blank. 7-10 Garmin G1000 Cockpit Reference Guide for the DA40 SECTION 8 ­ FLIGHT PLANNING SECTION 8: FLIGHT PLANNING The following discussions pertain to the Multi-function Display, unless otherwise indicated. 3. Turn the large FMS knob to highlight the latitude/longitude field or the Reference Waypoints field, depending on how the waypoint is to be defined. Turn the FMS knobs to enter the position coordinates or the radial and distance from the reference waypoint. Press the ENT key to accept the new waypoint. Press the FMS knob to remove the flashing cursor. 8. 1 USER DEFINED WAYPOINTS 4. 5. 6. Create User Waypoints from the Navigation Map Page 1. With the Navigation Map Page displayed, push the joystick to activate the panning function. The target pointer is displayed at the present aircraft position. After placing the pointer at the desired position, press the ENT key. The User Waypoint Information Page is now displayed with the captured position. Turn the FMS knobs to select a waypoint name. Press the ENT key to accept the selected name. The first reference waypoint field is highlighted. If desired, turn the FMS knobs to enter the identifier of the reference waypoint and the radial and distance to the reference waypoint. Press the FMS knob to remove the flashing cursor. 2. Figure 8-1 User WPT Information Page Select the User WPT Information Page 1. [. . . ] This can also occur with user waypoints in a flight plan that is deleted. Remove the waypoint from the flight plan if it no longer exists in any database, OR update the waypoint name/identifier to reflect the new information. FPL WPT MOVE ­ Flight plan The system has detected that a waypoint coordinate has changed due to a new waypoint moved. Verify that stored flight plans contain correct waypoint locations. [. . . ]