User manual GARMIN G1000 MOONEY PILOTS GUIDE 0424.20

[. . . ] Mooney M20M/M20R/M20TN Copyright © 2006 Garmin Ltd. This manual reflects the operation of System Software version 0424. 20 or later. Some differences in operation may be observed when comparing the information in this manual to earlier or later software versions. Garmin International, Inc. , 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. [. . . ] The APPROACH window is displayed on the `PROC ­ APPROACH LOADING' Page. 6) Select a transition (the `VECTORS' option assumes vectors will be received to the final course segment of the approach and will provide navigation guidance relative to the final approach course. ) 7) Press the ENT Key. 8) Highlight `LOAD?' or `ACTIVATE?'. `LOAD' adds the approach to the flight plan without immediately using the approach for navigation guidance. This allows for the original flight plan to continue navigating until cleared for the approach, but keeps the approach available for quick activation when needed. `ACTIVATE' adds the approach to the flight plan and begins navigating the approach course. 9) If the approach is not approved for GPS, a `NOT APPROVED FOR GPS' messages is displayed with `YES' highlighted. Press the ENT Key to acknowledge the message. To cancel the approach, select `NO' and press the ENT Key. 190-00647-00 Rev. A Garmin G1000 Pilot's Guide for the Mooney M20M/M20R/M20TN 5-81 GPS NAVIGATION Figure 5-69 `Not Approved for GPS' Message Loading an approach procedure using the Active Flight Plan Page Menu: 1) From the Active Flight Plan Page, press the MENU Key. 2) Highlight `Load Approach' 3) Press the ENT Key. The APPROACH window is displayed on the `PROC ­ APPROACH LOADING' Page. 4) Select an approach and press the ENT Key. 5) Select a transition (the `VECTORS' option assumes vectors will be received to the final course segment of the approach and will provide navigation guidance relative to the final approach course). 7) Highlight `LOAD?' or `ACTIVATE?'. `LOAD' adds the approach to the flight plan without immediately using the approach for navigation guidance. This allows for the original flight plan to continue navigating until cleared for the approach, but keeps the approach available for quick activation when needed. `Activate' adds the approach to the flight plan and begins navigating the approach course. 8) If the approach is not approved for GPS, a `NOT APPROVED FOR GPS' messages is displayed with `YES' highlighted. Press the ENT Key to acknowledge the message. To cancel the approach, select `NO' and press the ENT Key. LOAD ARRIVAL A published standard terminal arrival route (STAR) for the destination airport can be loaded into the flight plan using one of three methods: · LD STAR Softkey · PROC Key · Active Flight Plan Page Options Menu The loaded arrival replaces the current arrival with the new selection. 5-82 Garmin G1000 Pilot's Guide for the Mooney M20M/M20R/M20TN 190-00647-00 Rev. A GPS NAVIGATION Loading an arrival procedure using the LD STAR Softkey: 1) From the Active Flight Plan Page, select the LD STAR Softkey. [. . . ] This is often the case in mountainous regions. TIS information is collected during a single radar sweep. Collected information is then sent through the Mode S uplink on the next radar sweep. Because of this, the surveillance information is approximately five seconds old. TIS ground station tracking software uses prediction algorithms to compensate for this delay. [. . . ]