User manual GARMIN G1000-DIAMOND SYSTEM SOFTWARE VERSION 0369.13 COCKPIT REFERENCE GUIDE

[. . . ] Integrated Flight Deck Cockpit Reference Guide Diamond DA40/40F SYSTEM OVERVIEW FLIGHT INSTRUMENTS ENGINE INDICATION SYSTEM NAV/COM/TRANSPONDER AUDIO PANEL AUTOMATIC FLIGHT CONTROL NAVIGATION FLIGHT PLANNING PROCEDURES HAZARD AVOIDANCE ABNORMAL OPERATIONS ANNUNCIATIONS & ALERTS INDEX Copyright © 2004-2007 Garmin Ltd. This manual reflects the operation of System Software version 0369. 13 or later for the Diamond DA40 and DA40F. Some differences in operation may be observed when comparing the information in this manual to earlier or later software versions. Garmin International, Inc. , 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. [. . . ] 11) Turn the small FMS Knob to enter the desired target altitude offset from the selected Direct-to. 12) Press the ENT Key to highlight `Activate?' or turn the large FMS Knob to highlight the `COURSE' field. 13) Turn the small FMS Knob to enter the desired course to the waypoint. 14) Press the ENT Key to highlight `ACTIVATE?'. 15) Press the ENT again to activate the Direct-to. Figure 7-8 Flight Plan Waypoint List (PFD) Select a Direct-to Destination to a Flight Plan Waypoint 1) While navigating an active flight plan, press the Direct-to ( ) Key. 2) Turn the small FMS Knob to the left to display a list of flight plan waypoints as shown in Figure 7-8. 3) Turn the large FMS Knob to select the desired waypoint. The cursor is now displayed on `ACTIVATE?'. 5) Press ENT again to activate a Direct-to. Select a Direct-to Destination to a Nearest Airport 1) Press the Direct-to ( ) Key. Initially, a flight plan waypoint list is displayed as in Figure 7-8. The list is only populated when navigating a flight plan. Figure 7-9 Nearest Airport List (PFD) 7-4 Garmin G1000 Cockpit Reference Guide for the DA40/40F 190-00324-07 Rev. A SECTION 7 ­ NAVIGATION 3) Turn the small FMS Knob to the right to display the `NRST' airports to the aircraft's current position as shown in Figure 7-9. 4) Turn the large FMS Knob to select the desired airport. The cursor is now displayed on `ACTIVATE?'. 6) Press ENT again to activate a Direct-to. Select a Direct-to Destination to a Recently Entered Identifier 1) Press the Direct-to ( ) Key. Initially, a flight plan waypoint list is displayed as in Figure 7-8. The list is only populated when navigating a flight plan. 3) Turn the small FMS Knob to the right to display the `RECENT' waypoints as shown in Figure 7-10. 2) Press the MENU Key to display the Options Window. The cursor will be flashing on `Cancel Direct-to NAV'. 3) Press the ENT Key to cancel the direct-to. 7. 3 NAVIGATING AN EXAMPLE FLIGHT PLAN The following discussion is an example of navigating a flight plan with the WAAS capable GPS system while the G1000 provides vertical guidance through descents. [. . . ] Excessive track The current track angle error exceeds the limit, causing the vertical deviation to angle error. Parallel course A parallel course has been selected, causing the vertical deviation to go invalid. NO WGS84 WPT ­ Non WGS 84 The selected waypoint [xxxx] does not use the WGS 84 datum. Cross-check waypoint for navigation -[xxxx] position with alternate navigation sources. [. . . ]