User manual GARMIN GPS 31 TRACPAK TECHNICAL SPECIFICATION

[. . . ] Unit 5, The Quadrangle, Abbey Park Industrial Estate, Romsey, SO51 9DL, U. K. 44/0870. 8501241 Fax 44/0870. 8501251 Garmin Corporation No. 68, Jangshu 2nd Road, Shijr, Taipei County, Taiwan Tel. 886/2. 2642. 9199 Fax 886/2. 2642. 9099 All rights reserved. [. . . ] Such repairs or replacement will be made at no charge to the customer for parts or labor, provided that the customer shall be responsible for any transportation cost. These items are available at most marine dealers. Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. When drilling or cutting, always check first to see what is on the opposite side of the surface. Mount the GPSMAP 2006C/2010C in a location that provides a clear, glare-free view of the display and easy operation of the controls. If you experience difficulty installing the unit, contact Garmin Product Support or seek the assistance of a professional installer. Mounting Knob Bail Mount Mounting Holes GPSMAP 2010C Shown GPSMAP 2006C/2010C & GPS 17 3 INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS Surface Mount Tools · · · · Drill and Drill Bit Screwdriver Pencil Mounting Hardware (not included) NOTE: Mounting hardware (fasteners) not included. Mounting holes are 5/16" (7. 9 mm) in diameter. Using the bail mount as a template, mark the location of the four mounting holes. Be sure to leave at least two inches of clearance behind the unit for the wiring. Using an appropriate size drill bit, drill pilot holes for the fasteners. Secure the bail mount to the surface with the fasteners. Be very careful when cutting this hole, there is only a small amount of clearance between the case molding and the Mounting Holes. Install the four Mounting Studs into unit by screwing the shorter, threaded section into the back of the unit. Use a 1/16" (2mm) Allen Wrench to tighten the Mounting Studs until the stop contacts the case. Be careful not to overtighten as this may damage the Mounting Stud!The studs have a reusable thread-locking patch pre-applied from the factory. Place the unit in position in the cut out of the mounting surface. Place washers over the Mounting Studs, then thread on one Hex Nut per Mounting Stud. Tighten all four until the unit is snug against the mounting surface. Install and tighten the second Hex Nut on all four Mounting Studs to lock the first one in place. 208mm DRILL A 3/8" HOLE. BEGIN CUTTING HERE Stud Flush Mount Template Washer Hex nuts Mounting surface GPSMAP 2006C/2010C & GPS 17 5 INSTALLATION INSTRUCTIONS Installing the GPS 17 The GPS 17 can be flush mounted or installed on any standard 1" O. D. (Outer Dimension), 14 threads-per-inch marine mount. [. . . ] If interference with other electronics is experienced, try a different location. NOTE: Never paint the GPS 17 or clean it with harsh solvents. ABOVE - BEST Radar BELOW - OK 3' Radar VHF Radio Antenna NOTE: Mount the antenna at least 3 ft away from (preferably above) the path of any radar beam or a VHF radio antenna. BETTER GOOD BEST EMI SS JAYHAWK EMI (Electromagnetic Interference) from engine components Signal Interference 1. Cut out the Mounting Template provided on page 11, and tape it on the selected mounting location. Mark the center of each mounting hole by tapping the end of a center punch or pointed object with a hammer. If the cable is going to be installed through the mounting panel, mark the center of the additional hole. [. . . ]