User manual GARMIN GTX 330 TRANSPONDER PILOT'S GUIDE

[. . . ] GTXTM 330/330D Mode S Transponder pilot's guide © Copyright 2002, 2007 Garmin Ltd. or its subsidiaries All Rights Reserved Except as expressly provided herein, no part of this manual may be reproduced, copied, transmitted, disseminated, downloaded or stored in any storage medium, for any purpose without the express prior written consent of Garmin. Garmin hereby grants permission to download a single copy of this manual and of any revision to this manual onto a hard drive or other electronic storage medium to be viewed and to print one copy of this manual or of any revision hereto, provided that such electronic or printed copy of this manual or revision must contain the complete text of this copyright notice and provided further that any unauthorized commercial distribution of this manual or any revision hereto is strictly prohibited. This manual is written for software version 4. 06 or later, and is not suitable for earlier software versions. [. . . ] CRSR Initiates starting time entry for the Count Down timer and cancels transponder code entry. CLR Resets the Count Up, Count Down, and Flight timers. Cancels the previous keypress during code selection and Count Down entry. Returns cursor to the fourth code digit within five seconds after entry. 8 Reduces Contrast and Display Brightness when the respective fields are displayed (dependent upon installation configuration) and enters the number eight into the Count Down timer. 9 Increases Contrast and Display Brightness when the respective fields are displayed (dependent upon installation configuration) and enters the number nine into the Count Down timer. Function Display PRESSURE ALT: Displays the altitude data supplied to the GTX 330 in feet, hundreds of feet (i. e. , flight level), or meters (dependent upon installation configuration). FLIGHT TIME: Timer start is configured as either Manual or Automatic. When Manual, displays the Flight Time, controlled by the START/STOP and CLR keys. When Automatic, the timer begins when take off is sensed. ALTITUDE MONITOR: Controlled by START/STOP key. Activates a voice alarm and warning annunciator when altitude limit is exceeded. OAT/DALT: Displayed when the GTX 330 is configured with temperature input. Displays Outside Air Temperature and Density Altitude. COUNT UP TIMER: Controlled by START/STOP and CLR keys. COUNT DOWN TIMER: Controlled by START/STOP, CLR, and CRSR keys. The initial Count Down time is entered with the 0 ­ 9 keys. CONTRAST: This page is only displayed if manual contrast mode is selected during installation configuration. Contrast is controlled by the 8 and 9 keys. DISPLAY: This page is only displayed if manual backlighting mode is selected during installation configuration. Backlighting is controlled by the 8 and 9 keys. Altitude Trend Indicator When the PRESSURE ALT page is displayed, an arrow may be displayed to the right of the altitude, indicating that the altitude is increasing or decreasing. One of two sizes of arrows may be displayed depending on the vertical speed rate. The sensitivity of these arrows is initially set during transponder installation. [. . . ] For example, to enter the letter R press the 5 key four times. Each time an alphanumeric character is entered, press the CRSR key to move the cursor to the next blank field. Pressing the CLR key moves the cursor back to the previous character. After the complete FLT ID is entered, press the CRSR key to move the cursor to the OK? [. . . ]