User manual GARMIN MONTERRA

[. . . ] Monterra ? Owner?s Manual October 2013 190-01601-00_0A Printed in Taiwan All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www. garmin. com for current updates and supplemental information concerning the use of this product. [. . . ] Audible tones signal turns in the route. ? Elevation Plot By default, the elevation plot displays the elevation over the distance traveled. ?To customize the elevation settings, see page9. ?You can touch any point on the plot to view details about that point. ? Navigating with the Compass When navigating to a destination, points to your destination, regardless of the direction you are moving. ?1 Begin navigating to a destination (page5). ?3 Turn until points toward the top of the compass, and continue moving in that direction to the destination. ? Navigating to a Point on the Plot 1 Select Elevation Plot. ?2 Select an individual point on the plot. ? Details about the point appear. ? 3 Select > View Map. ?4 Select the information bar at the top of the screen. ?5 Select Go. ? The map opens with your route marked with a magenta line. ?6 Navigate using the map (page5) or compass (page5). ? Calibrating the Compass NOTICE Calibrate the electronic compass outdoors. ?To improve heading accuracy, do not stand near objects that influence magnetic fields, such as vehicles, buildings, and overhead power lines. ?Your device was already calibrated at the factory, and the device uses automatic calibration by default. ?If you experience irregular compass behavior, for example, after moving long distances or after extreme temperature changes, you can manually calibrate the compass. ?1 Select Compass > > Calibrate Compass > Start. ?2 Follow the on-screen instructions. ? Changing the Plot Type You can change the elevation plot to display pressure and elevation over time or distance. ?1 Select Elevation Plot > > Change Plot Type. ?2 Select an option. ? Resetting the Elevation Plot Select Elevation Plot > > Reset. ? Calibrating the Barometric Altimeter Your device was already calibrated at the factory, and the device uses automatic calibration by default. ?You can manually calibrate the barometric altimeter if you know the correct elevation or the correct barometric pressure. ?1 Go to a location where the elevation or barometric pressure is known. ?2 Select Elevation Plot > > Calibrate Altimeter. ?3 Follow the on-screen instructions. ? Course Pointer The course pointer is most useful if you are navigating on water or where there are no major obstacles in your path. ?It also can also help you avoid hazards to either side of the course, such as shoals or submerged rocks. ?To enable the course pointer, from the compass, select Settings > Heading Settings > Go to Line/Pointer > Course (CDI). ? Trip Computer The trip computer displays your current speed, average speed, maximum speed, trip odometer, and other helpful statistics. ? [. . . ] On Mac computers, the device and memory card appear as mounted volumes. ?NOTE: Some computers with multiple network drives may not display device drives properly. ?See your operating system documentation to learn how to map the drive. ?On your computer, open the file browser. ? [. . . ]