User manual GARY FISHER 2002 GARY FISHER BICYCLES

[. . . ] Bicycle Owner's Manual 1 CONGRATULATIONS! Congratulations for choosing a Gary Fisher® bicycle. We have carefully constructed your bicycle so that its safety and performance meet the highest standards. Your Fisher dealer has helped you choose the size and model to meet your personal requirements and has assembled and adjusted it. With proper care and maintenance, your new Fisher bicycle will give you riding pleasure for years to come. [. . . ] Next, turn the high gear adjusting screw (usually marked "H") counterclockwise until it cannot interfere with the motion of the derailleur. While pedaling the bicycle with your hand, carefully shift onto the outside chainring. Position the front derailleur with the left thumb shift lever so that the outer chain guide of the front derailleur is approximately 0. 5 mm from the chain. Re-tighten the high gear adjusting screw until it meets resistance. If you have turned it too far, the front derailleur will move toward the smaller chainring. Right Shift lever/Rear derailleur To make the high gear adjustment on the rear derailleur, shift the chain onto the smallest rear cog and the largest front chainring, then loosen the rear derailleur cable clamp bolt until the cable is free. Stand behind the bicycle to see that the smallest rear cog, the chain, and the two derailleur pulleys are in line. If they are not aligned, turn the high gear adjusting screw (usually marked "H") until this line is established. While pulling on the rear derailleur cable, push the right finger shift lever until the shifter is in the small cog position. Screw the adjusting barrel on the right shift lever to it's most clockwise position. Screw the adjusting barrel on the rear derailleur to it's most clockwise position, and then rotate it one turn counter-clockwise. Pull the shift cable taut, insert the cable into the clamp bolt groove on the rear derailleur, and tighten the cable clamp bolt to 32-52 lb·in (3. 6-5. 9 Nm). To make the low gear adjustment on the rear derailleur, first turn the low gear adjusting screw on the rear derailleur (usually marked "L") far enough counter-clockwise so that it will not restrict the movement of the derailleur. While pedaling the bicycle with your hand, carefully shift the chain onto the smallest front chainring and the largest rear cog. Do not over-shift the rear derailleur, or the chain may wedge between the large cog and 30 the spokes. Position the rear derailleur pulleys in line with the largest cog. Turn the low gear adjusting screw clockwise until it meets resistance. If you have turned it too far, the derailleur will move toward the outside of the bicycle. Go through the various gear combinations. Make sure the chain does not fall off when you shift. To align the indexing system of your rear derailleur, shift the chain onto the largest front chainring, and the smallest rear cog. Push the right thumb shift lever to shift the chain onto the next smallest rear cog. If the chain makes excessive noise or does not shift, rotate the rear derailleur barrel adjuster counter-clockwise (increasing cable tension) to align the derailleur pulleys with this second cog. [. . . ] Avoid pulling, tearing, or cutting these wires, as damaging the wires will cause the light to cease to function. Installing bulbs To install a new bulb, locate the lens set-screw on the back of either the taillight or head light (Fig. Remove the screw with a Phillips screwdriver. After the screw has been completely removed, rotate the lens 1/4 turn clockwise and lift the lens assembly off the bulb mount. You may then unscrew the bulb, being careful not to crush the glass of the bulb. [. . . ]