User manual GAS GAS ENDUCROSS MC 125 PART LIST 2005 PART 1

[. . . ] The present manual will offer you a good basic knowledge of the vehicle's characteristics and handling. It contains important instructions about your safety and information on the necessary skills and techniques required to handle it, as well as the basic maintenance and inspection proceedings. Thanks for your confidence and welcome to GAS GAS Motos, S. A. August 2003 WILD HP -68- COMMON ADVICE Read this manual thoroughly. [. . . ] The progressive strut system features an ÖHLINS multi-adjustment shock absorber. Like the front suspension, it can be adapted to different riding styles. Adjusting rebound To adjust the rebound, turn the knob located in the lower part of the shock absorber (C) manually. There are a total of 28 possible adjustments. The standard setting is 13 "clicks". Turn the knob clockwise to its end, now it is totally closed. Turn 13 "clicks" anti-clockwise and now the setting is the standard one. With 0 clicks, the rebound would be very hard, and with 28 clicks would be very soft. There are 56 positions available in total. The standard setting is 28 "clicks". Totally hard compression is 0 "clicks". Totally soft compression is 38 "clicks". (A) Adjusting compression To adjust the compression settings, turn the knob on the top end of the shock absorber with a flat tip screwdriver. - Remove the brake pad cap (F) (in the inside of the wheels) and attach a transparent tube to its end. CHECKING THE BRAKE FLUID LEVEL (F) NOTE Inspect the brake fluid and change it regularly. You may also change it if it appears to be contaminated with water or dirt. Inspection of the brake fluid Front: The small brake fluid reservoir is located to the left of the throttle grip. If we look at the reservoir carefully we will see one of the sides with a small bubble which will allow us to control what happens inside the reservoir. If you have just purchased your quad, you will see nothing through the bubble because the reservoir is full. You will when the fluid level descends, then you will be able to control the level decrease. - Activate the brake several times. You will see that fluid starts exiting the system through the tube. The transparent tube will help us see if there is air, i. e. - Once the system has been bled, refill the reservoir to the top. Rear brake pedal Check the brake operation and make sure it does not rub against any other part of the QUAD. [. . . ] Obligation of the purchaser GG shall be entitled to refuse to accept warranty claims if and to the extent that: a) The purchaser has failed to subject the vehicle to any of the inspections and/or maintenance work prescribed in the operating manual or has exceeded the date stated for such inspections or maintenance work, also excluding from the warranty defects that appeared before the prescribed date of such inspection or maintenance work performed not at all or performed only after the prescribed date. b) Inspection, maintenance work and repair work on the vehicle has been performed by a party neither recognized nor licensed by GG; c) Any maintenance or repair work has been performed on the vehicle in violation of the technical requirements, specifications and instructions indicated by the manufacturer. d) Spare parts not released for use by GG have been used to perform maintenance or repair work on the vehicle, or if and to the extent that the vehicle has been operated using other fuels, lubricants or operating fluids (including but not limited to cleaning agents) than those expressly stated in the specifications in the operating manual; e) The vehicle has been altered or modified in any way or equipped with other components than those expressly released by GG as admissible vehicle components. f) The vehicle has been stored or transported in a way that does not meet the corresponding technical requirements. [. . . ]