User manual GAS GAS ENDUCROSS SM 200 PART LIST 2005 PART 1

[. . . ] With your skills at the commands of this motorbike, an adequate preparation and the indispensable servicing for this GAS GAS to be highly reliable, you will be able to enjoy the most comfortable and rewarding enduro practice. Thanks for your confidence and welcome to GAS GAS Motos. July 2003 ENDUCROSS SM 200 2004 -64- COMMON NOTICE Whenever you see the symbols shown below, heed their instructions!Always follow safe operating and maintenance practices. [. . . ] Adjust the oil level as required within the adjustable range using the following oil: Recomended oil MARZOCCHI SAE 7´5 WP. SAE 5 ÖHLINS 5 - 7'5 ENDUCROSS SM 200 2004 -93- (1). Lock nut wrench Fork Springs Different fork springs are available to achieve suitable front fork action in accordance with the rider´s weight and track conditions. - Harder springs make the fork stiffer, and rebound action quicker. - Softer sprigs make the fork softer, and rebound action slower. Fork Clamp Position Adjustment Steering qualities are greatly affected by the fork clamp position (the amount of the outer tube projecting above the steering stem head). When the fork tube height is smaller, the front end becomes lighter due to change in weight bias. Also, it tends to understeer in turns at «whash out». When the height is greater, the results are opposite. Be sure the front tire doesn´t rub the fender when the fork tubes compress fully. CAUTION The outer tubes, both right and left, should be adjusted evenly. ENDUCROSS SM 200 2004 -94- (A). Push Rod - Pull up the push rod (A) slowly. Lock nut (ring) - Tighten the locknut (ring) securely. - After adjustment, move the spring up and down to make sure that the spring is seated. Rear Shock Absorber Spring Replacement In addigtion to the standard spring, harder and softer springs are available. If the standard spring is improper for your purpose, select a proper one according to the rider´s weight or course conditions. - Using the harder spring:The spring rate is higher. - Using the softer spring:The spring rate is lower. NOTE Look at page 106. ENDUCROSS SM 200 2004 -96- (B) (A) (A). Llave tensador radios WARINING Improper removal of the spring from the rear shock absorber body may cause the spring and associated parts to be ejected at high velocity. Removal and installation of spring should be performed by an person or company. WHEELS Tires - Tire pressure affects traction, handling, and tire life. - Adjust the tire pressure to suit track conditions and rider preference, but do not stray too far from the recommended pressure. [. . . ] Obligation of the purchaser GG shall be entitled to refuse to accept warranty claims if and to the extent that: a) The purchaser has failed to subject the vehicle to any of the inspections and/or maintenance work prescribed in the operating manual or has exceeded the date stated for such inspections or maintenance work, also excluding from the warranty defects that appeared before the prescribed date of such inspection or maintenance work performed not at all or performed only after the prescribed date. b) Inspection, maintenance work and repair work on the vehicle has been performed by a party neither recognized nor licensed by GG; c) Any maintenance or repair work has been performed on the vehicle in violation of the technical requirements, specifications and instructions indicated by the manufacturer. d) Spare parts not released for use by GG have been used to perform maintenance or repair work on the vehicle, or if and to the extent that the vehicle has been operated using other fuels, lubricants or operating fluids (including but not limited to cleaning agents) than those expressly stated in the specifications in the operating manual; e) The vehicle has been altered or modified in any way or equipped with other components than those expressly released by GG as admissible vehicle components. f) The vehicle has been stored or transported in a way that does not meet the corresponding technical requirements. [. . . ]