User manual GAS GAS TXT CADETE 2007

[. . . ] This sign introduces special warnings to avoid damaging your motorbike. Should these warnings not be heeded, the guarantee may be automatically invalidated. These are the indications necessary for the optimal control and adjustment operations, together with those tasks of conservation and maintenance of the motorbike in order that you may obtain the greatest possible satisfaction from your vehicle. [. . . ] Check this valve is working properly. C To tense and centre the rear wheel, the hub is fitted with easily adjustable eccentrics. C 7 22 7 The chain fixing link should be fitted so it faces against the direction of movement. C 23 The tension on the chain should allow an oscillation of 1. 5 cm where it passes through the tensor. C -15- 7 24 7 7 25 26 27 a -16- Dismantle and clean periodically the main nozzle after washing the bike, as well as cleaning the inside of the carburettor housing. C C It is necessary to clean the carburettor very thoroughly. To do so use compressed air. C It is important to check the level of petrol within the carburettor. The height of the float is = 15 mm. 7 After many hours of use the clutch discs should be checked for possible wear. The minimum size for their correct working is 15 mm. C The springs that exert pressure on the clutch should have a length of between 28 and 29 mm. C 29 30 a 28 C The distance between the plates and the limits should be = 8 mm. -17- 7 7 After any operation involving the dismantling or putting back together of the clutch operating circuit, any remaining air can be eliminated using the air bleed (A). C 31 7 A B C C The circle indicates where the radiator should be drained (B). 7 C -18- To check the oil level, first make sure the motorbike is in a stable position on a horizontal surface. If the bike has been in use, wait a few minutes. To check the oil level, unscrew the cap (C) and examine the level of oil using the dip-stick. The level should be between the marked maximum and minimum levels. If it is too low, add the necessary quantity by opening the oil cap. Use the same type and make of lubricant as that which is already in the engine. 32 Check the level of clutch fluid periodically by looking through the transparent spyhole mounted in the tank. C 33 C Each of the suspension bars is filled with SAE 5 oil. TXT Rookie: 310 cm3 TXT Cadete: 210 cm3 -19- 7 7 34 C C 7 The front suspension is manually adjustable. To the right (extension), to the left (hydraulic compression). 8 a a 35 The front suspension cap should not exceed the following measurements: Rookie a = 3 mm Cadete a = 0 mm 9. 5 mm 36 7 7 C The front suspension of the TXT Cadete model is not fitted with adjustment. -20- C It is important to periodically dismantle and check the state of the bearings and the rocker spports. 7 The pressure of the shock absorber spring can be adjusted by turning the cogs (A) using a key. Length of spring: -Rookie 140 mm -Cadete 135 mm Periodically, the joints of the lower part of the rear suspension should be cleaned, the adjustments checked, and lubricated. C C 37 39 38 7 C -21- 7 The rear brake fluid tank (B) is in the centre of the chassis. The brake pads, both front and rear, should be checked for wear periodically, in order to enable you to brake effectively in any situation. C 40 8 41 7 7 42 7 -22- C The level of brake fluid can be checked using the transparent observation panel in the tank. To eliminate any air trapped in the brake circuit, the shoes are fitted with air bleeds. C 7 C The control panel only contains a motor cut out button. 43 Fron 0, 450 t tyre pres 0, 420 bar - stand sure: bar - c a ompe rd tition Rea 0, 350 r tyre pres 0, 300 bar - standsure: bar - c a ompe rd tition 44 Check regularly tyre pressures in order to obtain the best road-holding possible. -23- C 7 The fuel tank cap twists off. You are recommended to check regularly the state of the rubber seal in order to ensure a correct closing. C 45 -24- 7 WARRANTY TERMS AND CONDITIONS (According to Law decree 23/2003 on the 10th of July, covering Warranties on Consumer Item Sales). Warranty terms of the manufacturer GASGAS Motos, S. A. (hereafter referred to as "GG"), with this present document guarantees the consumer, the purchaser of a vehicle manufactured by GG, that both the materials and the manufacturing are free of defects in accordance with the highest standards of quality. [. . . ] 2. - In case of doubt regarding the existence of a defect, or a visual or material inspection is required, GG reserves the right to demand the return of the parts which are the object of a claim under Warranty, or to arrange an inspection of the defect by an expert from GG. Any additional obligations arising out of guarantees on parts replaced free of charge, or any other service rendered free of charge, are excluded from the effects of this present warranty. The Warranty on parts replaced within the Warranty Period will end at the expiry date for the Warranty Period of the product concerned. [. . . ]