User manual GATEWAY LD-220

[. . . ] For customer service and support, call 1-800-846-2301 between 7am - 10pm Centeral Time Monday through Friday If you need technical support after setting up your system, login to the Gateway Support website at http://suport. gateway. com INTRODUCTION UNPACKING AND INSTALLATION READ THIS BEFORE OPERATING YOUR UNIT This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Note to CATV System Installer : This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] The change can be seen on the left-upper angle of the TV screen. L F E TITLE R CHAPT MIN SEC 0dB adjust volume ¡¾ L F E TITLE R CHAPT MINTONE SEC +3dB TITLE LFE CHAPT MIN SEC TRIM f. When LS audio channel appears on the display screen, adjust the volume on remote or front panel. The output will convert from ­10dB to +10dB. L F E TITLE LS CHAPT MIN SEC 0dB b. When TRB appears on the display screen, adjust the volume on remote or front panel. The output will convert from ­10dB to +10dB. L F E adjust volume ¡¾ L F E TITLE LS CHAPT MINTONE SEC +3dB TITLE TRB CHAPT MIN SEC 0dB adjust volume ¡¾ L F E g. When RS audio channel appears on the display screen, adjust the volume on remote or front panel. The output will convert from -10dB to +10dB. L F E TITLE TRB CHAPT MINTONE SEC -3dB TITLE RS CHAPT MIN SEC 0dB adjust volume ¡¾ c. When BASS appears on the display screen, adjust the volume on remote or front panel. The output will convert from ­10dB to +10dB. L F E TITLE RS CHAPT MINTONE SEC +3dB 19 www. gateway. com FUNCTION AND OPERATION EXPLANATION h. When C audio channel appears on the display screen, adjust the volume on remote or front panel. The output will convert from ­10dB to +10dB. L F E TITLE C CHAPT MIN SEC 0dB adjust volume ¡¾ L F E TITLE C CHAPT MINTONE SEC +3dB 18. PRO LOGIC II ­ Opposed to Dolby Pro Logic, which had four channels (front, left, center, and surround) record into two channels with matrix processing and then played back in four channels, Dolby Pro Logic II uses a feedback logic circuit to have 5. 1-channel surround audio (Dolby Surround, etc. ) matrix-encoded into two channels and then played back in its original 5. 1-channel form. There are five standard modes; Movie, Music, Virtual, Pro Logic Emulation, and Matrix. A list of menu setting items i. When SUB audio channel appears on the display screen, adjust the volume on remote or front panel. The output will convert from ­10dB to +10dB. L F E SETUP MENU. . . . . . MAIN PAGE GENERAL SETUP SPEAKER SETUP AUDIO SETUP PREFERENCES EXIT SETUP GENERAL PAGE TV DISPLAY ANGLE MARK NORMAL/PS NORMAL/LB WIDE ON OFF ENGLISH FRENCH SPANISH CHINESE JAPANESE ON OFF ON OFF TITLE SUB CHAPT MIN SEC 0dB adjust volume ¡¾ L F E TITLE SUB CHAPT MINTONE SEC +3dB B. STEREO MODE Press the CH SEL key (37/remote control) repeatedly, the following loop will be displayed on the display screen: OSD LANG CAPTIONS Refer to the above b, c, d, e, i in the 5. 1CH mode to adjust each audio channel output to select a satisfactory display effect. Press the SETUP key (14/remote control), ". . . MAIN PAGE. . . " appears on the TV screen. During setup, use the 4 shift keys and the functional key SELECT/ENTER on front panel or remote control, to complete your desired functional setting. DOWNMIX TEST TONE CNTR DELAY 17. PRO LOGIC ­ Before playing a CD, VCD, or 2CH DVD, make the following settings to get 4. 1CH output: L, C, R, SUB and S. Setting: SPEAKER SETUP to 5. 1CH, and PRO LOGIC to ON in AUDIO SETUP item. REAR DELAY STEREO 5. 1CH ON OFF -- -- 5MS -- --- -- 3MS -- --- -- 1MS -- -- OFF -- -- 15MS -- --- -- 9MS -- --- -- 3MS -- -- OFF MAIN PAGE www. gateway. com 20 FUNCTION AND OPERATION EXPLANATION AUDIO PAGE AUDIO OUT How to use menu picture ANALOG SPDIF/RAW SPDIF/PCM STEREO L-MONO R-MONO MIX-MONO -- -- Full -- --- -- 6/8 -- --- -- 4/8 -- --- -- 2/8 -- -- OFF OFF ON PROLOGIC VIRTUAL MUSIC MOVIE MATRIX CUST LPCM 48K LPCM 96K You can use the menu picture to make the initial setting, adjust the picture, etc. [. . . ] If there is any inconsistency between this Agreement and any other agreement included with or relating to products or services purchased from Gateway, this Agreement shall govern. This Agreement may not be modified, altered or amended without the written agreement of Gateway. Any additional or altered terms attached to your order shall be null and void, unless expressly agreed to in writing by Gateway. If any term of this Agreement is illegal or unenforceable, the legality and enforceability of the remaining provisions shall not be affected or impaired. [. . . ]