User manual GE INTERLOGIX SIMON

[. . . ] ) ZZZ*(, QWHUORJL[6HFXULW\FRP 466-1871 Rev F September 2002 *( , QWHUORJL[ Part No: 60-875 Doors & Motion Windows Sensors System Status HOME SECURITY Arm 1/2 3/4 Disarm 5/6 7/8 9/0 CODE Chime Doors Motion Time Sensor On Off HOME CONTROL Bypass Lights EMERGENCY FIRE POLICE AUX Test Weekly Simon Security System User Guide FCC Notices FCC Part 15 Information to the User Changes or modifications not expressly approved by Interlogix Inc. can void the user's authority to operate the equipment. FCC Part 15 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference in a residential installation. [. . . ] The panel voice prompts you to Use numbered keys to enter ID. Enter your master access code using the numbered keys. The panel voice prompts you to Please select from START MENU. The panel voice prompts you to Select from MAIN MENU. Press the Light Control button on the MAIN MENU. The panel voice responds with House Code is *, press again to change or press unit number. This is the House Code that was set by your installer. The panel responds with Unit #1 press again to change or select from control menu. Keep pressing the Unit # button until the correct unit is selected. Press the Time button on the control menu. The panel voice prompts you, On time is **** to change press hours and minutes then press done. Press the Hours and Minutes buttons to set the correct on time. Panel will announce, Off time is **** to change press hours and minutes then press done. Press the Hours and Minutes buttons to set the correct off time. Panel will announce the unit number with the on and off times you just programmed. Programming Options The following table is a list of options you can change. Programming Options Option # 01 - Panel Beeps 02 - Panel Voice 03 - Latchkey Time 36 - Sensor Activated Light Lockout Start Time 37 - Sensor Activated Light Lockout Stop Time 41 - Chime Voice 42 - Speaker Volume 43 - Pager Phone Number 55 - Status Beep Volume 81 - Heating Set Point 82 - Cooling Set Point On On 12:00 am (midnight) to 11:59 pm 12:00 am (midnight) to 11:59 pm 12:00 am (midnight) to 11:59 pm On 1-8 Up to 26 digits* 1 - 10 51F - 91F 51F - 91F Add Delete Off Off Off Off Off Off 8 (highest) Off 7 Off Off * See "Option 43 - Pager Phone Number" Press Add in the START MENU and follow the voice prompts to turn an option on. Press Delete in the START MENU to turn an option off. When entering a single digit option number (1-9), you must type a zero before the number (i. e. All option numbers must be 2 digits. 15 Simon Security System Option 01 - Status Beeps Add this option to enable panel beeps. Status beeps are any beeps (including chime beeps) that come from the panel. Panel announces, Use numbered keys to enter ID. Enter Access Code using the numbered keys. Panel announces, Please select from Start Menu. [. . . ] Sensors may not detect smoke in other levels of the building. Sensors may not warn in time when fires are caused by smoking in bed, explosions, improper storage of flammables, overloaded electrical circuits, or other hazardous conditions. If telephone lines are out of service. Inadequate maintenance is the most common cause of alarm failure. Therefore, test your system at least once per week to be sure sensors, sirens, and phone communications are all working correctly. [. . . ]