User manual GE PHONE MODEL 27907

[. . . ] Model 27907 Series DECT 6. 0 Cordless Handset Speakerphone Answering System User's Guide Your new GE telephone system is EXPANDABLE up to a total of 4 handsets (by purchase of optional Model 27907 handset with charge cradle) Equipment Approval Information Your telephone equipment is approved for connection to the Public Switched Telephone Network and is in compliance with parts 15 and 68, FCC Rules and Regulations and the Technical Requirements for Telephone Terminal Equipment published by ACTA. 1 Notification to the Local Telephone Company On the bottom of this equipment is a label indicating, among other information, the US number and Ringer Equivalence Number (REN) for the equipment. You must, upon request, provide this information to your telephone company. The REN is useful in determining the number of devices you may connect to your telephone line and still have all of these devices ring when your telephone number is called. [. . . ] If your handset is not registered, follow the instructions in the Registration section of this manual. Handset to Handset Paging (applicable only with additional handsets) 1. Make sure the phone is OFF (not in talk mode). Press and release the int button on a handset. Use the touch-tone pad to enter the handset number you want to page. To cancel the page, press the exit, int, or TALK/CALL BACK button on the originating handset, or press the exit button on the receiving handset. Paging All Handsets from a Handset (applicable only with additional handsets) 1. Make sure the originating phone is OFF (not in talk mode). Press and release the int button on a handset. Use the touch-tone pad to enter the handset number you want to page. (1= to page Handset 1, =to page handset , etc. , and 5=to page all handsets) . To cancel the page, press the exit, int, or TALK/CALL BACK button on the originating handset, or press the exit button on the receiving handset. 5 Paging from the Base/Group Page Use the base-only to page all registered handsets at the same time. All handsets beep for two minutes, and PAGING FROM BASE shows on each handset's display. To cancel the page, press the page button on the base, or press the TALK/CALL BACK button or the exit button on each handset. Mute To have a private, off-line conversation, use the MUTE feature. The party on the telephone line cannot hear you, but you can hear them. Press the mute/program button to cancel and return to your phone conversation. Receiver Volume Control When the handset is ON (in talk mode) you may adjust the receiver volume by pressing the caller ID-volume ( 6 or 5) button. There are four volume levels to choose from. When the maximum or minimum volume level is reached, the phone beeps twice. 6 Volume Boost During a conversation, you may increase the volume by pressing the Volume Boost button on the side of the handset, AUDIO BOOST will show in display. The volume will return to its original setting when you hang up the phone or if you press the Vol Boost button again during conversation. NOTE: The Volume Boost feature can be turned on at any Volume Level setting during conversation. Also, the volume level can still be adjusted after the Audio Boost Feature is enabled by using the CALLER ID-VOLUME (6 or 5) button. Intercom Operation (applicable only with additional handsets) The intercom feature allows you to have a conversation with another registered handset without tying up the telephone line, allowing you to still receive incoming calls. Making an Intercom Call 1. Make sure the handset is OFF (not in talk mode). Use the touch-tone pad to select the handset you want to page. [. . . ] What your warranty does not cover: · Customer instruction. (Your Owner's Manual provides information regarding operating instructions and user controls. Any additional information, should be obtained from your dealer. ) · Installation and setup service adjustments. · Products which have been modified or incorporated into other products. [. . . ]