User manual GE SECURITY RANGER 9000E REV C

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. [. . . ] Enter primary ACCESS CODE + [2 OR 3] to arm the system to the desired level. Enter primary ACCESS CODE + BYPASS + [SENSOR #]. The panel announces, Sensor [sensor #] bypassed. Repeat step 2 to bypass another sensor. NOTE: You cannot bypass fire sensors, which include smoke, heat, and fire pull sensors. But you can bypass 24-hour police and auxiliary/ medical sensors, including sensors in level 1 (see Table 5 for sensor numbers). 3. s To remove all sensor bypasses: Change the security level. s To remove a single sensor bypass: 1. Enter primary ACCESS CODE + BYPASS + [SENSOR #]. The panel announces, Sensor [sensor #] ON. If the panel announces, Invalid, try again, check that the sensor is closed, then repeat step 1. Repeat step 1 to remove another sensor bypass. Using the Chime Feature (CHIME) 7 CHIME s The Chime feature causes the system to sound chime beeps whenever a monitored perimeter door or window is opened. Chime only works in level 1, when the system is disarmed. To turn Chime on or off: 1. Enter ACCESS CODE + 1 from the panel or a touchpad to disarm the system. The panel announces, [new temporary access code] OK. NOTE: You can enter your current temporary access code in place of a new temporary access code if you do not want to change your code. 2. Enter the number of days (00-99) you want the Key to work. If you enter 00, the Key will work until midnight of the day the Key is programmed. For numbers greater than 00, the Key will work until midnight of the assigned day. Insert the Key into the slot within 30 seconds of changing your temporary access code (see Figure 4). Hold the Key in the slot until the panel announces, Memory OK. NOTE: You must reprogram the Magic Key if you change the temporary access code. 3. 4. Magic Key Voice Messages Table 6 describes voice messages you may hear when programming or using a Magic Key. Table 6. Magic Key Voice Messages Message Memory OK Invalid, try again. Definition Programming successfully completed. Key's programming prevents its use at this time. Reprogram Key or revalidate the temporary access code. Using the Keychain Touchpad This section summarizes all the functions of the Keychain Touchpad. You can perform the following functions using the Keychain Touchpad: Arm the system Arm the system with no alarm delay time Disarm the system 32 s Activate an alarm Turn system-controlled lights on and off. [. . . ] bypass Have the system ignore selected sensors while the system is armed. For example, to open a monitored door while the system is armed to level 2, bypass the door's sensor. central monitoring station See monitoring service. delay The time you have to enter the premises and disarm the system before an alarm occurs, or the time you have to exit the premises after arming the system before an alarm occurs. [. . . ]