User manual GE 490000 REV A

[. . . ] This manual contains safety information to make you aware of the hazards and risks associated with engines and how to avoid them. It also contains instructions for the proper use and care of the engine. Because Briggs & Stratton Corporation does not necessarily know what equipment this engine will power, it is important that you read and understand these instructions and the instructions for the equipment. Save these original instructions for future reference. [. . . ] Other parts may not perform as well, may damage the unit, and may result in injury. Do not strike the flywheel with a hammer or hard object because the flywheel may later shatter during operation. when testing for spark: Use approved spark plug tester. Do not check for spark with spark plug removed. Remove accumulated debris from muffler area and cylinder area. If damage is found, install replacement parts before operating. Other parts may not perform as well, may damage the unit, and may result in injury. Used oil is a hazardous waste product and must be disposed of properly. Check with your local authorities, service center, or dealer for safe disposal/recycling facilities. First 5 Hours Change oil With engine off but still warm, disconnect the spark plug wire (A) and keep it away from the spark plug (Figure 4). Every 8 Hours or Daily Check engine oil level Note: Any of the oil drain plugs shown below may be installed in the engine. Clean air filter * Change engine oil Replace oil filter (if equipped) Check muffler and spark arrester (if equipped) After the oil has drained, install and tighten the oil drain plug. Carefully lower the quick oil drain (I) into an approved container (J). After the oil has drained, install the oil drain cap. Annually * Replace air filter Replace spark plugs Clean air cooling system * In dusty conditions or when airborne debris is present, clean more often. Before you install the new oil filter, lightly lubricate the oil filter gasket with fresh, clean oil. Install the oil filter by hand until the gasket contacts the oil filter adapter, then tighten the oil filter 1/2 to 3/4 turns. As the engine warms up, check for oil leaks. Stop the engine and check the oil level. see the Specifications section for oil capacity. Remove the dipstick (D) and wipe with a clean cloth (Figure 4). Pour the oil slowly into the engine oil fill (E). [. . . ] ignition System replacement point for the part. Spark plug(s) Magneto ignition system Add on or modified parts that are not exempted by the Air Resources Board may not be used. The use of any non exempted add on or modified parts by the d. catalyst System owner will be grounds for disallowing a warranty claim. [. . . ]