User manual GE AU 29878

[. . . ] Connect the plug of the power supply into the POWER 9V AC socket in the back of the answerer. Plug the other end into an AC Power outlet. The unit plays a long beep and announces "please wait" After the pause; the unit beeps again and is ready for setup or to answer calls with the default greeting and settings. (See page 4 for a diagram of the connections) 4 Connections Australia To Line Socket New Zealand To Power Outlet Controls and functions 5 Recording a greeting When recording the greeting you should be about 20cms from the unit. Eliminate as much background noise as possible. [. . . ] To store the first number, press and release the [STOP/SET] button. To change the second and third number, follow steps 2 and 3 above. After the third number is stored, the unit announces all the stored settings. Reviewing the settings This function allows you to review the current time, rings to answer, and security code. · Press and release the [STOP/SET] button to start the review. The unit announces the current settings. Adjusting the Volume Use the [VOLUME] + and ­ buttons to increase or decrease the volume. Three quick beeps are heard when the minimum and maximum levels are reached. Message Indicator The Message Indicator lets you know the status of the unit. STATUS Message indicator flashes continuously. Message indicator is on and not flashing. EXPLANATION New messages have been received; press [PLAY /MEMO] to hear your messages. No action required, unit is ready to receive calls. Press [ON/OFF] to turn unit on. 8 Playing messages When the message indicator flashes continuously you have received new messages. · · · · · · To play messages, press and release the [PLAY/MEMO] button. To stop play, press and release the [STOP/SET] button. To restart the message, press and release the [PREVIOUS] button. To go back to the beginning of a previous message, press and release the [PREVIOUS] button twice within one second. To skip the beginning of the next message, press and release the [NEXT] button. To erase a message while it is playing, press and release the [ERASE] button. The answerer announces, "Message Erased". Erasing all messages When the answerer is not playing or recording, press and hold the [ERASE] button until you hear, "Messages Erased". If you do not have any messages, the answerer will announce "Zero message". Leaving a memo 1. Record your message after the announcement and the beep are heard. The maximum recording time for MEMO is 60 seconds. Release the [PLAY/MEMO] button after you have finished talking. [. . . ] Set rings to answer to 4. Incoming messages are incomplete Does not respond to remote commands Answerer does not work Cannot hear messages Unit announces "Low Battery" Cannot restart the message Message indicator flashes rapidly Greeting continues to play even after an extension telephone is picked up 11 Warranty This product is warranted for a period of 12 months from the date of purchase. In the event of equipment failure, please return this product with the proof of purchase to the store where it was purchased. This waranty does not cover damage caused by lightning, power surge, misuse or neglect, vermin infestation, accidental damage or any alteration that affects the performance or reliability of the product. Remote Access Instruction Card Please cut out the remote access card below and keep it for reference during remote access. Fold here 29878 GE Answerer 1. Enter 3-digit security code during greeting or after the beep. [. . . ]