User manual GE PSC23MGMCC

[. . . ] For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. These numbers are located on your engine (see the Features and Controls page). Certain components in this product and its related accessories contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. [. . . ] NOTICE: To extend the life of the starter, use short starting cycles (five seconds maximum). Wait one minute between starting cycles. With the throttle control (B) in the slow position, turn the key switch (D) to the off position (Figure 3). Remove the key and keep in a safe place out of the reach of children. Push the stop switch (F) to the off position. After the engine stops, turn the fuel shut-off valve (A), if equipped, to the closed position. We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. NOTICE: All the components used to build this engine must remain in place for proper operation. Maintenance, replacement, or repair of the emissions control devices and systems may be performed by any non-road engine repair establishment or individual. However, to obtain "no charge" emissions control service, the work must be performed by a factory authorized dealer. Before performing adjustments or repairs: Disconnect the spark plug wire and keep it away from the spark plug. Check with your local authorities, service center, or dealer for safe disposal/recycling facilities. With engine off but still warm, disconnect the spark plug wire (A) and keep it away from the spark plug (Figure 8). After the oil has drained, install and tighten the oil drain plug. Some models are equipped with oil filter. Before you install the new oil filter, lightly lubricate the oil filter gasket with fresh, clean oil. Install the oil filter by hand until the gasket contacts the oil filter adapter, then tighten the oil filter 1/2 to 3/4 turns. As the engine warms up, check for oil leaks. Stop the engine and check the oil level. see the Specifications section for oil capacity. Remove the dipstick (D) and wipe with a clean cloth (Figure 11). Pour the oil slowly into the engine oil fill (E). [. . . ] carbon canister Any warranted part that is scheduled for replacement as required maintenance b. Air Induction System in the owner's manual supplied, is warranted for the period of time prior to the Air cleaner first scheduled replacement point for that part. If the part fails prior to the first Intake manifold scheduled replacement, the part will be repaired or replaced by B&S at no Purge and vent line charge to the owner. Any such part repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled c. [. . . ]