User manual GEHA OFFICE X15 CD

[. . . ] Always comply with the following basic precautions. This file shredder has been designed specifically for the shredding of paper and CDs. Do not attempt to feed foils, adhesive labels, clothing, or plastic materials into the file shredder. Remove all paper clips before shredding paper. [. . . ] When the sensor detects that the waste paper container is full, the device stops automatically and the red LED `Status' lights up, and the LCD display will show `Basket Full'. First remove all paper from the feeder, and then empty the waste paper container. Feeding cDs/DvDs and credit cards into the shredder This device can also shred CDs/DVDs and credit cards. Make sure that only 1 CD/DVD or 1 credit card is fed into the device at a time!If you would like to utilise this function, proceed as follows: 1. switch on the file shredder by pressing the ON/OFF button. The green LED `Status' lights up, and the operating mode (Ready) and current time are shown in the LED display. Any CDs/DVDs and credit cards in the slot are detected automatically, the device starts up and the operating mode `In Use' is shown on the LCD display. CDs/DVDs and credit cards are shredded into particles. Make sure to keep your face well away from the feeder slot when shredding CDs/DVDs, since these types of material always pose a hazard of splintering! the shredded material will not be collected in a separate container. Remove the shredded material before changing the to a different medium in order to facilitate an environmentally friendly disposal!By pressing the button `FWD`, you can now increase the hour displayed, and by pressing the button `REV` you can decrease the hour displayed. By pressing the button `FWD`, you can now increase the minutes displayed, and by pressing the button `REV` you can decrease the minutes displayed. Important note: The device will switch off automatically if the motor temperature increases too much. The LED `status' lights up in red and signals that the overheat protection of the device has been activated - the LcD display shows `Please Wait'. If that is the case, the device will not react when you press the button `rEv' or `fWD'. The device switches back into normaloperation as soon as the motor has cooled sufficiently. The number of sheets fed in is too high. Please wait until the display shows `Ready`. Continue operation when the display shows `Ready`. The door for the waste paper container is not closed. [. . . ] Fold the paper and insert it into the feeder again. If the device is still not working after you have tried the above solutions, please remove the mains power plug from the wall socket and consult your retailer. DIsPosaL The symbol depicting a crossed-out rubbish bin means that electrical devices may not be disposed of with regular household waste. please bring the device to an approved recycling centre for environmentally firendly disposal. [. . . ]