User manual GEMINI CDJ-15X

[. . . ] SERVICING: Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. refer all servicing to qualified service personnel. DAMAGE REQUIRING SERVICE: Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: · If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. [. . . ] If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. ⷠIf this product is equipped with a three-wire grounding type plug, a plug having a third (grounding) pin, it will only fit into a grounding type power outlet. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the grounding type plug. This state of the art professional CD player is backed by a three year warranty, excluding lasers. Prior to use, we suggest that you carefully read all the instructions. POWER SWITCH: After making sure that the VOLTAGE SELECTOR SLIDE (3), found on the rear panel, is properly set, plug the unit in and press the POWER (2) switch. Pushing the POWER (2) switch a second time will turn the unit off. DISPLAY: The DISPLAY (4) shows the track numbers, play mode, pause mode, and 3 different time displays. These time displays are time elapsed on the track, time remaining on the disc and time remaining on the track. PLAYBACK DISPLAY: The PLAYBACK DISPLAY (5) displays the time remaining to play and flashes slowly when the track has 30 seconds left. The PLAYBACK DISPLAY (5) flashes quickly when the track has 15 seconds left. PLAY/PAUSE : Each press of the PLAY/PAUSE (9) button causes the operation to change from play to pause or from pause back to play. Instant start 1-Bit linear 8 times oversampling Precise frame accurate cue searching ± 16% Variable pitch with ON/OFF button LCD display Three time display modes Single auto-cue/continuous play modes Forward & reverse stutter Translucent window Do not use this CD Player at temperatures below 41°F/5°C or higher than 95°F/35°C. The apparatus should not be exposed to dripping or splashing, and no objects filled with liquids such as vases should be placed on the apparatus. Place the unit in a clean and dry location. Do not place the unit in an unstable location. When disconnecting the power cord from an AC outlet, always grasp it by the plug. To prevent electric shock, do not remove the cover or the bottom screws. There are no user serviceable parts inside. Do not use chemical solvents to clean the unit. [. . . ] Track Elapsed, Track Remain, or Total remain Variable Pitch. Once you have saved a cue point you can fine tune or change the memorized cue point: To change a cue point, push PLAY/PAUSE (9) so the unit plays from the cue point, then press PLAY/PAUSE (9) at the spot you wish your new cue point to be. Press PLAY/PAUSE (9) again to save the cue point. The unit will go into the pause mode and the location indicated on the display will be the new memorized cue point. [. . . ]