User manual GEMINI PS-03

[. . . ] CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment. To prevent electromagnetic interference with electric appliances such as radios and televisions, use shielded cables and connectors for connections. the exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The lightening flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Once you have selected the proper line, slowly raise the CH1 FADER CONTROL (29) to a comfortable level. You can further modify the sound output of this channel by adjusting the rotary GAIN (24), HIGH (25), MID (27), LOW (26) controls located above the CH1 FADER CONTROL (29). CH2: To bring this channel into PGM, you must first decide which line will be in use. Use the LN SWITCH (30) to toggle from PH2/LN3 (14) to LN4 (13) on this channel. Once you have selected the proper line, slowly raise the CH2 FADER CONTROL (36) to a comfortable level. You can further modify the sound output of this channel by adjusting the rotary GAIN (31), HIGH (32), MID (34), LOW (33) controls located above the CH2 FADER CONTROL (36). CH3: To bring this channel in to PGM, you must first decide which line will be in use. Use the LN SWITCH (37) to toggle from PH3/LN5 (10) to LN6 (9) on this channel. Slowly raise the CH3 FADER CONTROL (43) to a comfortable level, once you have selected the proper line. You can further modify the sound output of this channel by adjusting the rotary GAIN (38), HIGH (39), MID (41), LOW (40) controls located above the CH3 FADER CONTROL (43). Do not expose this unit to direct sunlight or a heat source such as a radiator or stove. This unit should be cleaned only with a damp cloth. When moving this equipment it should be placed in its original carton and packaging. This will reduce the risk of damage during transit. Before plugging this unit into any outlet, make sure that the VOLTAGE SELECTION SWITCH (1) is set to the proper voltage. To change the selection, unscrew the hard plastic protective top with a Phillips head screw driver. Then use a flat head screw driver to move the switch to the proper selection (115V/230V). Plug into the rear panel POWER CORD (2) jack before plugging it into a proper power source. The PS-03 has 4 outputs located on the rear panel: - The MASTER RCA OUTPUT (5) connects the mixer to your main amplifier using standard audio cables with RCA-type connectors. - The BALANCED MASTER OUTPUT (8) connects the mixer to your main amplifier using standard cables with 1/4" connectors. We recommend using balanced cables if the distance to your amp is 10 feet or more. CUE: By connecting a set of headphones to the HEADPHONE (22) jack, you can monitor any or all channels. [. . . ] The FILTER RECALL (61) will be disengaged when changing the settings during FILTER RECALL (61). When the FILTER RECALL (61) button is in use, adjusting the filter setting after a setting has been stored into the memory will cancel the FILTER RECALL (61). You will notice the PGM output will change according to the filter setting. If you are satisfied with your setting, leave the FILTER RECALL (61) button alone. [. . . ]