User manual GEMINI TT-04

[. . . ] ATTACHMENTS: Do not use attachments not recommended by the product manuacturer as they may cause hazards. WATER AND MOISTURE: Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near a swimming pool; and the like. ACCESSORIES: Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. [. . . ] DAMAGE REQUIRING SERVICE: Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: · If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. ⷠIf the product has been dropped or damaged in any way. ⷠWhen the product exhibits a distinct change in performance, this indicates a need for service. REPLACEMENT PARTS: When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. SAFETY CHECK: Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. WALL OR CEILING MOUNTING: The product should not be mounted to a wall or ceiling. HEAT: The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. Prior to use, we suggest that you carefully read all the instructions. Hold PLATTER (2) using finger holes and rotate the motor spindle until PLATTER (2) base pins lock into motor. Set the TURNTABLE BASE (1) on a flat, level surface free of vibration. Use the turntable feet to stabilize the unit horizontally. Try to place the unit as far away from the speakers as possible. Keep the unit away from direct exposure to the sun, heat, moisture or dirt. - Fully manual direct drive turntable - Ultimate high torque (5 kg) direct drive turntable - Adjustable +/-10% or 20% pitch button w/ LED - Variable pitch slide control - Convenient retractable start/brake delay rotary controls - Solid aluminum platter with easy glide grooves and rubber damping - Silver metal plate w/ rubber painted base - Straight tone arm for superior tracking - Tone arm height finger groove adjustment up to 6 mm with lock - Fully adjustable counter weight & anti-skating controls - LED illuminated soft touch start/stop & RPM buttons - 33/45/78 RPM - Push button quartz lock and reverse w/ LED - Target light with RCA connector - Removable head shell - Felt slip mat included - Detachable RCA & ground cables Because all cartridges have their own designs, please refer to your particular cartridge's instructions to insure proper installation. If you are using a pre-mounted or integrated cartridge, you can jump ahead to HEADSHELL INSTALLATION. For your convenience, the terminals of most cartridges are color-coded. connect each lead wire to the terminal of the same color. In case your cartridge is not marked the positive leads are the ones on top negative below, left leads are the left channel, and right leads are the right channel. Mount the cartridge in the HEADSHELL (5) and tighten it with the screws included with the cartridge. Read all operating instructions before using this equipment. [. . . ] This will either start and/or stop the tracks with no lag time to get the record to the set RPM speed. rotate the START (18) & BRAKE (19) rotary controls counter clockwise to increase the delay. This will either START and/or STOP the record with a noticeable amount of lag time until the record has completely stopped or reached the set RPM speed. This feature is generally used when a larger or smaller sized cartridge is used for record playing. [. . . ]