User manual GENERAL ELECTRIC 21828

[. . . ] Precautions of Use The quality of communication depends on the location and environment of the base and the handset. The 21828 must be kept away from sources of excessive heat (radiators, direct sunlight, etc. ) and protected against vibrations and dust. Never allow your telephone to come into contact with water or other liquids or with aerosols. To reduce the risk of interference and optimize reception, take particular care to keep it away from the immediate vicinity of windows, large metal objects, reinforced concrete, televisions, music centres, halogen lamps or heating devices, fluorescent lighting, burglar alarms, microwave ovens, computers, etc. [. . . ] It is only possible to enter subscribers in the phone book who are not already entered. Muting the Microphone Press key to switch the microphone on or off during a call. Holding Calls / Forwarding Calls If the telephone is connected to a PABX system, it is possible to put calls on hold and call other extension lines or to forward calls. Press "R" key to put the call on hold and dial the extension number (e. g. Press "R" key once more to take the call back again or press key to forward the call. Note: If several handsets are registered on the base station and a call should be put on hold or forwarded, press "INT/OK" key instead of "R". Note: The above information can vary according to the PABX system used. or key to select submenu and press "INT/OK" Press or key to scroll through the phone book. Alternatively, enter the first letter of the name required. If editing, edit the number and name (using "C" for deleting). Press "INT/OK" key when finished. Handset Settings Changing the Ringing Volume Press key until the HANDSET menu appears and Press "INT/OK" key three times. Press or key to select the required volume and Press "INT/OK" key. Note: The ringer volume can be heard at different volumes. If the ringer symbol appears as non dotted line, the ringing volume will be switched to OFF. Changing the Ringer Melody (external / internal) Press key until the HANDSET menu appears and Press "INT/OK" key twice. Use or key to select the required submenu (EXT RINGER or INT RINGER) and press "INT/OK" key. Use or key to select the required melody (1-10) and press "INT/OK" key to confirm. Entering/Changing Handset Name It is possible to assign a name to each handset. This name is then displayed when the phone is in standby mode. Press key until the HANDSET menu appears and press "INT/OK" key. Press or key to select the submenu and press "INT/OK" key. Enter/change the name of the handset (e. g. MOBIL 1) and press "INT/OK" key to confirm. Switching the Key Tone On/Off Press key as often as necessary until the HANDSET menu appears and press "INT/OK" key. key to select the submenu and press key to select the setting and press "INT/OK" Saving a Prefix It is possible to save prefix numbers in the handset. This number is then recalled after pressing and hold "0" key for two seconds. Press key as often as necessary until the HANDSET menu appears and press "INT/OK" key. key to select the submenu and press 10 Enter prefix number (e. g. [. . . ] Telephone connection Appliance designed for connection to an analogue telephone line class TNV3 (telecommunications network voltage) as defined by the EN 60950 standard. Rechargeable Battery GP60AAAHC, 1. 2V / 600mAh / Ni-MH, AAA x 2 or equivalent Operating Temperature: 0 to 45 oC * For guidance only, depends on initial battery charge. 13 General Product Care Simply wipe the base station with a damp cloth or an antistatic wipe. Never use a dry cloth as this can cause static discharge. Troubleshooting Guide When you forget base PIN, following the procedure to Reset the units. Refer to handset ­ Call Log Operation procedure, select DELETE ALL to delete all Call Log Memories in handset. [. . . ]