User manual GENERAL ELECTRIC 25922

[. . . ] Model 25922 Series 5. 8 GHz Cordless Handset System User's Guide · If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this product does not disable your alarm equipment. · If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer. US Number is located on the cabinet bottom. REN Number is located on the cabinet bottom. [. . . ] Prompt confirming a CID record is erased. Indicates there is no additional information in the Caller ID memory log. Telling you to name the handset or enter a name for one of the 10 memory locations. Caller information is interrupted during transmission or the phone line is excessively noisy. Indicates the handset battery is low and needs charging. Indicates call or calls have not been reviewed. Indicates a new voice mail is available. Someone is paging the handset from the base. Indicates the handset needs to be registered before use. Indicates the CID number is a Directory Dial Number (DDN) and cannot be formatted. Indicates the handset is registered and available for use. Indicates that a new call from the same number was received more than once. Indicates the call is being transferred from one handset to another. Indicates the CID or memory contents cannot be dialed. Indicates the CID or memory contents cannot be stored. Or there has been a base power failure, in which case you must place all handsets on the main base cradle for 20 seconds to re-register. The incoming call is from an area not serviced by Caller ID or caller information is not sent. Troubleshooting Tips Caller ID Solutions No display · Fully charge (for 16 hours) or replace the battery. · If you are using AC (electrical) power, make sure that the unit is connected to a non-switched electrical outlet. Unplug the AC power converter from the unit and plug it back in. · To see Caller ID information in your display, you must be subscribed to Caller ID service through your local telephone company. Caller ID incomplete · The unit displays this message if it detects anything other than valid Caller ID information during the silent period after the first ring. This message indicates the presence of noise on the line. Out of range · Move closer to the base. [. . . ] You will hear a confirmation tone. UNKNOWN NAME/CALLER/ NUMBER Signal Handset Sound Signals Meaning Signals an incoming call Confirmation tone Low battery warning A long warbling tone (with ringer on) One long beep tone One beep every 7 seconds 2. Place the handset in the extra charging cradle. The charge indicator turns on, verifying the battery is charging. Allow the phone to charge for 16 hours. Deleting a CID Record 1. [. . . ]