User manual GENERAL ELECTRIC AGQ06

[. . . ] This generator system is designed and intended only for use as an optional home standby system that provides an alternate source of electric power and to serve loads such as heating, refrigeration systems, and communication systems that, when stopped during any power outage, could cause discomfort or inconvenience. Save these instructions for future reference. This generator requires professional installation before use. You never have to look far to find support and service for your generator. [. . . ] DO NOT lift or move generator without assistance. DO NOT lift unit by roof as damage to generator will occur. The home generator is equipped with several access openings and a removable roof to permit simple oil and filter servicing. To remove access cover: Remove the two screws, tilt cover out, and lift cover off panel. WarninG Contact with muffler area could cause burns resulting in serious injury. DO NOT touch hot parts and AVOID hot exhaust gases. Allow equipment to cool before touching. Each home generator is suppied with a set of identical keys. These keys fit the locks that secure the access door. Insert key into lock of access door and turn key one quarter turn counterclockwise. Grasp door's handle and turn one quarter turn counterclockwise to open. A typical final fuel connection assembly is shown here, where (a) is the fuel supply and (B) goes to the home generator. The generator has been factory set to run on natural gas. If you need to change from natural gas to LP gas, the unit will need to be reconfigured, as described in Fuel Conversion. Estimated fuel supply requirements at half and full load for natural gas and LP vapor fuels are shown here. C = Cubic feet per hour B = BTU's per hour Normal atmospheric state Boiling Point (in °f): initial end heating Value: Btu per gallon (net LhV*) Btu per gallon (gross**) cubic feet (gas) Density*** Weight octane number: research Motor Gross heat value does not consider heat lost in the form of water during combustion. *** Density is given in "Cubic Feet of Gas per Gallon of Liquid". Weight is given in "Pounds per Gallon of Liquid". Low Voltage connections to signal fault contacts, transfer switch communication, remote LED and auxiliary 12VDC power are made via a removable ten-pole connector plug. Compare this illustration with your generator to familiarize yourself with the location of these connections. Count down to the proper pin location on the control board since visual alignment with the decal can be misleading: A - fault contacts--UseNO, COMandNCtohookupa siren, light, etc. Contacts reverse state (NO goes to NC and vice versa) upon a fault condition. [. . . ] LP fuel inlet pressure must be between 11 and 14 inches water column at full load with all gas appliances turned on and operating. The system is now ready to operate automatically using LP vapor fuel. This control board constantly monitors utility power source voltage. Should that voltage drop below a preset level, control board action will signal the engine to crank and start. [. . . ]