User manual GENERAL ELECTRIC AGW05

[. . . ] Because we do not necessarily know all the applications this equipment could be used for, it is important that you read and understand these instructions thoroughly before attempting to start or operate this equipment. Save these instructions for future reference. This home standby generator requires professional installation before use. refer to the separate installation manual for full information. [. . . ] Missing or damaged parts are not warranted. Read this operator's manual and Important Safety Instructions before operating your generator. Compare the illustration with your generator to familiarize yourself with the locations of various controls and adjustments. Pull panel outward (away) from unit while pulling panel upward and out of base. Push panel until it is flush with sides. NOTICE Any attempt to crank or start the engine before it has been properly serviced with the recommended oil will result in equipment failure. Refer to Maintenance in the operator's manual and engine manual for oil fill information. Damage to equipment resulting from failure to follow this instruction will void engine and generator warranty. This engine is shipped from the factory pre-run and filled with synthetic oil (API SJ/CF 5W-30). this allows for system operation in a wide range of temperature and climate conditions. Before starting the engine, check oil level as described in the engine manual. This date and time is then used to automatically initiate the system exercise cycle. Choose the day and time you want your home generator to exercise. On that day and time, press and hold "SET EXERCISE" for three seconds. "SET EXERCISE" will flash until the button is pressed for three seconds, then "SET EXERCISE" will illuminate for 5 seconds, and finally turn off. The unit will then start and run it's 20 minute exercise cycle. For example, if you press SET EXERCISE on Sunday morning at 10:00 AM, the unit will run an immediate exercise cycle and an exercise cycle every following Sunday at 10:00 AM (+/- 1/2 hour). "Set Exercise" will only work if the unit is in the AUTO mode and this exact procedure is followed. The exerciser will need to be re-set if the 15 Amp fuse is removed or changed, or if the starting battery is disconnected. If you want to change the day and time the unit exercises, simply perform the "Set Exercise" procedure at the exact weekday and time you want it to take place. Before performing any generator maintenance, always perform the following steps: 1. Disconnect power before servicing control panel by removing the fuses from the transfer switch. [. . . ] This warranty gives you specific legal rights and you may also have other rights which vary from state to state or country to country. The warranty period begins on the date of purchase by the first retail consumer or commercial end user, and continues for the period of time stated in the table above. "Consumer" means personal residential household use by a retail consumer. "Commercial" means all other uses, including use for commercial, income producing or rental purposes. [. . . ]