User manual GENERAL ELECTRIC SIMON

[. . . ] ) ZZZ*(, QWHUORJL[FRP 466-1871 Rev J May 2003 *( , QWHUORJL[ Part No: 60-875 Doors & Motion Windows Sensors System Status HOME SECURITY Arm 1/2 3/4 Disarm 5/6 7/8 9/0 CODE Chime Doors Motion Time Sensor On Off HOME CONTROL Bypass Lights EMERGENCY FIRE POLICE AUX Test Weekly Simon Security System User Guide FCC Notices FCC Part 15 Information to the User Changes or modifications not expressly approved by Interlogix Inc. can void the user's authority to operate the equipment. FCC Part 15 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference in a residential installation. [. . . ] The panel voice prompts you to Select from MAIN MENU. Press the Access Code button on the MAIN MENU. The panel voice responds with Access Code 1, press again for next access code, DONE to select or press CANCEL to quit. Press the access code button again to hear the next access code. When you hear the access code you wish to delete, press the DONE Button. The panel voice responds with Access Code X deleted. Close the panel cover. Light Control You system has the ability to control lights from the panel. A specific light or group of lights can be programmed to turn on and off at designated times. House Code Refers to a group of lights that can be controlled from the panel. Note The panel lists house codes A - O. Ask your installer what house code your lights are set up on. Your house code for lights is ___. Simon Security System 15 Unit Number Refers to a specific light within a house code. 2. How to set time for light control: Open the cover of the panel. The panel voice prompts you to Use numbered keys to enter ID. Enter your master access code using the numbered keys. The panel voice prompts you to Please select from START MENU. The panel voice prompts you to Select from MAIN MENU. Press the Light Control button on the MAIN MENU. The panel voice responds with House Code is *, press again to change or press unit number. This is the House Code that was set by your installer. The panel responds with Unit #1 press again to change or select from control menu. Keep pressing the Unit # button until the correct unit is selected. Press the Time button on the control menu. The panel voice prompts you, On time is **** to change press hours and minutes then press done. [. . . ] Sensors may not detect smoke in other levels of the building. Sensors may not warn in time when fires are caused by smoking in bed, explosions, improper storage of flammables, overloaded electrical circuits, or other hazardous conditions. If telephone lines are out of service. Inadequate maintenance is the most common cause of alarm failure. Therefore, test your system at least once per week to be sure sensors, sirens, and phone communications are all working correctly. [. . . ]