User manual GENIUS SPEED WHEEL 3 VIBRATION

[. . . ] CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment. Disclaimer The following does not apply to any country where such provisions are inconsistent with local law: KYE Systems Corp. Makes no warranties with respect to this documentation, whether expressed or implied. [. . . ] all material is provided "as is". This includes, but is not limited to, any implied warranties of merchantability and fitness is for a particular purpose. The information covered in this document is subject to change without notice. Assumes no responsibility for any errors that may appear in this document. All brand names mentioned in this manual are trademarks or registered trademarks of their respective companies. Software Installation: Install the driver first before you install Speed Wheel 5 Pro to the system. The Wheel will not support the vibration function, if the driver is not installed. With the help of Key Mapping, we will be able to duplicate the function to our favor hardware key. please note that we can only set the Key_Mapping function at Key 5/6/7/8 , Brake Pedal and Acceleration pedal. For each Key_Mapping operation, you will only can duplicate one key to another. Press your favor TARGET key which you would like to copy that function to it. Then, press the SOURCE key to duplicate its function to the TARGET key to complete the procedure. tURBO LED will be off to indicate the function duplication is complete. Proceed the procedures again for another function duplication. [. . . ] Proceed the procedures again for another function duplication. Press theTARGET key which you would like to release that function. Then, Press and hold Key_10/Start, and press Key_Turbo at the same time to release the function. [. . . ]