User manual GEONAUTE SYNKRON 400

[. . . ] - During the warranty period, the item will either be repaired free of charge by an authorized repair service or replaced free of charge (depending on the distributor). - The guarantee does not cover batteries or cracked or broken casings where signs of a blow are evident. EN 21 S4 MI UV UV INDEX 11 P LO 14. 0 T1 S1 7 12 3 1 12:3845 WE 1-01 S3 4 S2 5 1 - Time 2 - Minute 3 - Second 4 - Day of the week 5 - Date 6 - Alarm indicator 7 - Chime indicator 8 - UV index icon 9 - UV index value, temperature 10 - Moon phase 11 - Tide indicator 12 - Time zone indicator 20 NORMAL CONDITIONS OF USE This watch is designed to be worn on the wrist, for leisure and light sports activities. It is for telling the time and measuring lap times, thanks to its stopwatch function. This watch measures numerous parameters of the environment: UV index, temperature, moon phases, and tide schedules. will go back to normal once it has cooled down again. [. . . ] This treatment of your electronic waste will protect the environment and your health. 1 - Time mode (TIME) S1 : alternate between temperature/UV index displays S2 : change the time zone S3 : switch to the next mode. S4 : quick press: electroluminescence long press: enter setting mode S4 MI UV LO UV INDEX 14. 0 T1 S1 P 12:3845 WE 1-01 S3 S2 NAVIGATION SYSTEM This watch has 7 operating modes: A time mode An alarm mode A stopwatch mode A countdown mode A tide schedule mode A temperature mode A UV index measurement mode The procedure for going from one mode to another is shown in the following diagram: S3 Time/date Alarm S3 Stopwatch S3 Countdown feature Recall S3 S3 S3 Tide S3 Temperature S3 UV In normal mode, the watch displays the time and the date, including the day of the week, as well as the temperature, the UV index and the tides. SETTING THE TIME · Press on S4 for 2 seconds: enter time setting mode and the "NIGHT OFF" symbol will flash. · Press on S1: activate the "NIGHT ON" option (electroluminescence when you press on each function): the "moon and star" symbol is displayed (press on S2 to deactivate this option). · Press on S3: the 12/24h symbols will flash. · Press on S1: set the time display mode (12 hours, 24 hours). · Press on S3: the hours will flash. Proceed in this manner to successively set the minutes, the seconds, the year, the month and the day of the month. S4 24 25 EN · Press on S4 at any time to exit time setting mode. The day of the week is calculated automatically within a period from 2003 to 2053. 2 - Alarm mode (ALARM) S1 : activate/deactivate the alarm S2 : activate/deactivate the hourly beep S4 S3 : switch to the next mode. S4 : quick press: S3 electroluminescence long press: set the alarm UV INDEX MI UV LO DISPLAY OF MOON MODES On the watch, an icon indicates the current moon phase. A full cycle of the moon lasts 29. 5 days. The phases are indicated according to the table below: 14. 0 T1 S1 P 12:00AL WE 1-01 S2 3 2 USING THE ALARM 4 · Press on S1: activate and deactivate the selected alarm. · Press on S2: reset the countdown to a preset value. 14. 0 P TMR 05'12. 21 USING THE TIDE SCHEDULE FUNCTION The tides are a natural phenomenon of rising and falling of the sea level in relation to land, influenced by the gravitational attraction of the Earth and the sun. The moon plays a larger role than the sun in this phenomenon. 31 SETTING THE VALUE OF THE COUNTDOWN · Press on S4 for 2 seconds: enter setting mode and the hour digits will flash. · Press on S1 or S2: set the hours. 30 EN 4 - Countdown mode · Press on S3: the minute digits will flash. · Press on S1 or S2: set the minutes. · Press on S3: the seconds digits will flash. · Press on S1 or S2: set the seconds. · Press on S3: the type of countdown flashes. · Press on S1 or S2: set the type of countdown. · Press on S4 at any time to exit setting mode. The starting value of the countdown may be set to 23 hours, 59 minutes, 59 seconds. The tide cycle is approximately 12 hours and 42 minutes when the influence of the earth/moon system is isolated. Nevertheless, numerous factors influence the tides: the shape of the coast, the depth of the water, the ocean currents, the wind and the weather. [. . . ] Under extreme conditions, values higher than 14 do exist. This watch displays a maximum value of 14. Important: these rays are very harmful; it is crucial to protect yourself from them. UV rays can be broken down into 5 main categories: UV INDEX 0-2 Intensity very weak Level Icon MI UV LO LO CALIBRATING FUNCTION THE TEMPERATURE 3-4 weak MI UV 5-6 average MI UV 7-9 strong MI UV 10+ very strong MI UV LO In temperature mode: · Press on S4 for 2 seconds: enter temperature calibration mode and the temperature will flash. [. . . ]