User manual GERICOM SILVER SERAPH P4

[. . . ] Declares, that the product: conforms to the following Standards: Erklärt, daß das Produkt: folgenden Normen entspricht: Déclarent que le produit cité ci-dessocus: est conforme aux normes suivantes: Declaran que el producto: cumple los sigulentes estándares: Dichiara, che il prodotto:è conforme alle seguenti norme: Intygar att produkten: överensstämmer med föijande normer: Supplementary Information: "The product complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89336/EEC. This product was designed to fulfil the EMC (electromagnetic compatibility) requirement to be observed for so-called "Residential, commercial and light industry environments". Do not approve the use of this product in working environments other than the above-mentioned "Residential, commercial and light industry environments". For example, the following environments are not approved: · Industrial Environments (environments with a mains volt age >230V~) · NOTE: If this product is supplied with a network port, please refer to the paragraph «Network connection». [. . . ] Let the CD dry completely before inserting it in the drive. You can purchase additional PC Cards from your dealer. most PC Cards conform to the PCMCIA (Personal Computer Memory Card International Association) standard. Your computer comes with two stacked PC Card slots and supports two types of PC Card: · Type II cards are typically used for fax/modems, memory storage, network cards, etc. You can install up to two of these cards, one in each slot. Type III cards are used for removable hard disks and other functions that require a larger card. You can install just one of these cards. Other cards may work with your computer, but are likely to be much more difficult to set up and use. PC Cards require Card and Socket Services software a set of programs that acts as a translator between the PC Card and the computer, and that makes hot swapping (switching cards while the computer is on) possible. Even if your PC Card comes with its own version of Card and Socket Services, you should use the files included in Microsoft® Windows® series operating system. Some PC Cards do not support Hot swapping. If your PC Card does not support hot swapping, save your data and turn off the computer before inserting the PC Card. Align the card connectors with an available PC Card slot and carefully slide the card into the slot until it locks into place. there are two eject buttons , one per slot. When the PC card is seated, the eject button for that slot pops out. Press the eject button to put it in its retracted position. NOTE: If you have a Type III card, insert the connector into the lower slot. If you have a Type II card, insert it into either the upper or the lower slot. NOTE: An HDD or CD-ROM connected to a 16-bit PC card, might affect the performance of the computer's sound system and data transmission, including slower transmission speeds and dialing errors. CAUTION: To avoid damaging the computer or the PC Card, don't force the card into the slot. Click Stop xxxx where xxxx is the name of the PC Card you want to stop. CAUTION: If your PC Card supports hot swapping, you can remove it at any time. [. . . ] If you have followed the recommendations in this chapter and are still having problems, you may need additional technical assistance. This section contains the steps to take to ask for help. Since some problems may be related to the operating system or the program you are using, it is important to investigate other sources of assistance first. Try the following before contacting : · If the problem occurs while you are running a program, consult the program's documentation for troubleshooting suggestions. [. . . ]