User manual GIANT BICYCLES GIANT PRE-RUNNER

[. . . ] Maximum load is 75lbs, including passenger and cargo. Make sure your child remains seated in the stroller at all times. Be sure the stroller frame is completely unfolded with latching mechanisms secure and wheels locked in the place, before allowing children near the stroller. Check that all buckles, snaps, straps and adjustments are secure before each use. [. . . ] Release button and test wheel is locked in place. The wheel must be firmly locked in place. Repeat the process for both rear wheels. PreRunner LX, 20" Wheels Firmly depress the gray button marked push. Insert the front wheel into axle tube on the front fork. Release button and test wheel is locked in place. The wheel must be firmly locked in place b. PreRunner, 16" Wheels Move quick release lever so that the word "OPEN" stamped on the lever arm shows to the outside. Insert the front wheel between the fork blades so that the axle seats firmly at the top of slots, which are at the tips of fork blades - the fork dropout. Flip quick release lever so that the word "CLOSED" stamped on the lever arm shows to the outside. Closing quick release lever should get progressively firmer until it is solidly fixed in the closed position. If quick release lever cannot be fully closed, loosen thumbnut on the opposite end of the skewer and try to close it again. If the lever goes to the closed position too easily or feels loose in the closed position, open the lever and tighten thumbnut, then try closing again. Quick release lever should be parallel to the front fork blade when in final closed position. CAUTION: DO NOT operate stroller if wheels do not firmly lock in place. STEP #3 - Install the Handlebar & Stem Assembly Giant PreRunner Jog Stroller has bicycle style handlebar and stem that allows the handlebar height to be adjusted to accommodate a wide variety of users. Loosen the handlebar binder bolts then remove the stem clamp -(Fig. a) on the plastic shim at the top of the stroller frame then tighten the handlebar binder bolts so that the stem will stay in place by itself, but is still easy to adjust. Try to find the best position for the user and tighten the handlebar and stem binder bolts. Push down the handle bar to raise the front wheel to test that the Be bolts were sufficiently tightened. STEP #4 - Install the Footrest fender on the Frame Assemble footrest fender as shown in the diagram. Align the heads of the bolts to fit into the matching recesses in the footrest fender. CAUTION: Avoid crushing the frame tubing DO NOT OVER TIGHTEN BOLTS! [. . . ] There is a brake lever at the handlebar that is connected to a brake mechanism at the front wheel. Squeeze the brake lever to make sure that it moves freely, but does not bottom out against the handlebar. Before using the stroller with a child test the brake and make sure that you can cause the front wheel to seize using the brake lever. If not, use the barrel adjusters at the brake lever and the brake mechanism on the front wheel to adjust the cable tension until the brake works to your satisfaction. [. . . ]