User manual GIGABYTE 8I945PE-FS

[. . . ] 8I945PE-FS Intel® Pentium® 4 LGA775 Processor Motherboard User's Manual Rev. 1001 8I945PE-FS Motherboard Layout CPU_FAN COMA IT8712 SPDIF 8I945PE USB USB 1394 LGA775 LAN ATX_12V AUDIO Intel 945P DDRII1 DDRII2 DDRII3 DDRII4 PCIE_16 ATX IDE 82562 PCI1 BIOS PCI2 TSB43AB23 F_1394 F_USB1 CLR_CMOS F_PANEL F_USB2 ICH7 BAT SATA1 SATA0 FS BIOS_RE FDD CODEC F-AUDIO AUX_IN BZ PCIE_1 SYS_FAN -2- SATA3 SATA2 Block Diagram LGA775 Processor CPUCLK+/-(200/133MHz) PCI-ECLK(100MHz) Host Interface PCI Express x16 Intel 945P MCH DDRII 667/533/400MHz DIMM Dual Channel Memory MCHCLK (133/200MHz) 66MHz 33MHz 14. 318MHz 48MHz BIOS 1 PCI Express x 1 Port PCI-ECLK(100MHz) PCI Express x1 Bus PCI Bus 4 Serial ATA Intel ICH7 ATA33/66/100 IDE Channels Floppy 82562 IT8712 COM Port RJ45 CODEC 8 USB Ports 24MHz 33MHz Center/Subwoofer Speaker Out Surround Speaker Out Side Speaker Out MIC Line-Out Line-In 2 PCI PCICLK(33MHz) -3- SPDIF Out English Chapter 1 Hardware Installation 1-1 CPU Feature Summary Supports Intel® Pentium® D / Pentium® 4 LGA775 CPU Supports 1066/800/533MHz FSB L2 cache varies with CPU Northbridge: Intel® 945P Express chipset Southbridge: Intel® ICH7 Supported on the Win 2000/XP/MCE operating systems 4 DDRII DIMM memory slots (supports up to 4GB memory) (Note 1) Supports dual channel DDR II 667(Note 2)/533/400 DIMM Supports 1. 8V DDR II DIMM 1 PCI Express x 16 slot 1 PCI Express x 1 slot 2 PCI slots 1 IDE connection (UDMA 33/ATA 66/ATA 100), allows connection of 2 IDE devices 1 FDD connection, allows connection of 2 FDD devices 4 SATA 3Gb/s connections Supported on the Win 2000/XP/MCE operating systems 1 parallel port supporting Normal/EPP/ECP mode 1 COMA port 8 USB 2. 0/1. 1 ports 1 front audio connector Onboard 82562 chip (10/100 Mbit) 1 RJ 45 port ALC880 CODEC Supports Jack Sensing function Supports 2 / 4 / 6 / 8 channel audio Supports Line In ; Line Out (Front Speaker Out) ; MIC ; Surround Speaker Out (Rear Speaker Out) ; Center/Subwoofer Speaker Out ; Side Speaker Out connection Supports SPDIF Out connection AUX_In Chipset Memory Slots IDE Connections FDD Connections Onboard SATA 3Gb/s Peripherals Onboard LAN Onboard Audio (Note 1) Due to standard PC architecture, a certain amount of memory is reserved for system usage and therefore the actual memory size is less than the stated amount. For example, 4 GB of memory size will instead be shown as 3. xxGB memory during system startup. (Note 2) To use a DDRII 667 memory module on the motherboard, you must install an 800/1066MHz FSB processor . [. . . ] Week The week, from Sun to Sat, determined by the BIOS and is display only Month The month, Jan. Day The day, from 1 to 31 (or the maximum allowed in the month) Year The year, from 1999 through 2098 Time The times format in <hour> <minute> <second>. The time is calculated base on the 24-hour military-time clock. is 13:00:00. IDE Channel 0 Master, Slave IDE HDD Auto-Detection Press "Enter" to select this option for automatic device detection. You can use one of three methods: Auto Allows BIOS to automatically detect IDE devices during POST(default) None Select this if no IDE devices are used and the system will skip the automatic detection step and allow for faster system start up. Manual User can manually input the correct settings Access Mode Use this to set the access mode for the hard drive. The four options are: CHS/LBA/Large/Auto(default:Auto) IDE Channel 2/3 Master, Slave IDE HDD Auto-Detection Press "Enter" to select this option for automatic device detection. You can use one of two methods: Auto Allows BIOS to automatically detect SATA IDE devices during POST. (Default value) None Select this if no SATA IDE devices are used and the system will skip the automatic detection step and allow for faster system start up. Access Mode Use this to set the access mode for the hard drive. The two options are: Large/Auto(default:Auto) GA-8I945PE-FS Motherboard - 24 - Capacity Capacity of currently installed hard disk. Hard drive information should be labeled on the outside drive casing. Enter the appropriate option based on this information. Cylinder Number of cylinders Head Number of heads Precomp Write precomp Landing Zone Landing zone Sector Number of sectors English Drive A The category identifies the types of floppy disk drive A that has been installed in the computer. None No floppy drive installed 360K, 5. 25" 5. 25 inch PC-type standard drive; 360K byte capacity. 1. 2M, 5. 25" 5. 25 inch AT-type high-density drive; 1. 2M byte capacity (3. 5 inch when 3 Mode is Enabled). 720K, 3. 5" 3. 5 inch double-sided drive; 720K byte capacity 1. 44M, 3. 5" 3. 5 inch double-sided drive; 1. 44M byte capacity. 2. 88M, 3. 5" 3. 5 inch double-sided drive; 2. 88M byte capacity. Halt on The category determines whether the computer will stop if an error is detected during power up. No Errors The system boot will not stop for any error that may be detected and you will be prompted. All Errors Whenever the BIOS detects a non-fatal error the system will be stopped. All, But Keyboard The system boot will not stop for a keyboard error; it will stop for all other errors. (Default value) All, But Diskette The system boot will not stop for a disk error; it will stop for all other errors. [. . . ] for FSB(Front Side Bus) frequency=1066MHz, 1. 5 Memory Frequency = Host clock X 1. 5. 2. 0 Memory Frequency = Host clock X 2. 0. 2. 5 Memory Frequency = Host clock X 2. 5. Auto Set Memory frequency by DRAM SPD data. [. . . ]