User manual GIGABYTE 8S661FXM-RZ

[. . . ] 8S661FXM-RZ Intel Pentium® 4 Processor Motherboard User's Manual Rev. 1101 12ME-S661FXMRZ-1101 Copyright © 2004 GIGABYTE TECHNOLOGY CO. , LTD Copyright by GIGA-BYTE TECHNOLOGY CO. , LTD. No part of this manual may be reproduced or transmitted in any from without the expressed, written permission of GBT. Trademarks Third-party brands and names are the property of their respective owners. Notice Please do not remove any labels on motherboard, this may void the warranty of this motherboard. Due to rapid change in technology, some of the specifications might be out of date before publication of this booklet. [. . . ] 1. 2M, 5. 25" 5. 25 inch AT-type high-density drive; 1. 2M byte capacity (3. 5 inch when 3 Mode is Enabled). 720K, 3. 5" 3. 5 inch double-sided drive; 720K byte capacity 1. 44M, 3. 5" 3. 5 inch double-sided drive; 1. 44M byte capacity. 2. 88M, 3. 5" 3. 5 inch double-sided drive; 2. 88M byte capacity. Floppy 3 Mode Support (for Japan Area) Disabled Drive A Drive B Both Normal Floppy Drive. (Default value) Enable Drive A 3 Mode support. Enable both Drive A and B 3 Mode support. Halt on The category determines whether the computer will stop if an error is detected during power up. All Errors Whenever the BIOS detects a non-fatal error the system will stop. No Errors The system boot will not stop for any error that may be detected and you will be prompted. All, But Keyboard The system boot will not stop for a keyboard error; it will stop for all other errors. (Default value) All, But Diskette The system boot will not stop for a disk error; it will stop for all other errors. All, But Disk/Key The system boot will not stop for a keyboard or disk error; it will stop for all other errors. Memory The category is display-only which is determined by POST (Power On Self Test) of the BIOS. Base Memory The POST of the BIOS will determine the amount of base (or conventional) memory installed in the system. The value of the base memory is typically 512K for systems with 512K memory installed on the motherboard, or 640K for systems with 640K or more memory installed on the motherboard. Extended Memory The BIOS determines how much extended memory is present during the POST. This is the amount of memory located above 1 MB in the CPU's memory address map. 8S661FXM-RZ Motherboard - 24 - Advanced BIOS Features CMOS Setup Utility-Copyright (C) 1984-2004 Award Software Advanced BIOS Features First Boot Device Second Boot Device Third Boot Device Boot Up Floppy Seek Password Check CPU Hyper-Threading # Init Display First [Floppy] [HDD-0] [CDROM] [Disabled] [Setup] [Enabled] [AGP] Item Help Menu Level} Select Boot Device Priority [Floppy] Boot from floppy [LS120] Boot from LS120 [HDD-0] Boot from First HDD [HDD-1] Boot from Second HDD higf: Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Save Defaults ESC: Exit F1: General Help F7: Optimized Defaults English "#" This option appears only when the Intel Pentium ® 4 processor you install on the system supports the Hyper-Threading Technology. First / Second / Third Boot Device Floppy LS120 HDD-0~3 SCSI CDROM ZIP USB-FDD USB-ZIP USB-CDROM USB-HDD LAN Disabled Select Select Select Select Select Select Select Select Select Select Select Select your boot device priority by Floppy. your boot device priority by Disabled. Boot Up Floppy Seek During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360K type is 40 tracks 720K, 1. 2M and 1. 44M are all 80 tracks. Disabled BIOS will not search for the type of floppy disk drive by track number. Note that there will not be any warning message if the drive installed is 360K. (Default value) Enabled BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks. Note that BIOS can not tell from 720K, 1. 2M or 1. 44M drive type as they are - 25 - BIOS Setup English Password Check Setup The system will boot but will not access to Setup page if the correct password is not entered at the prompt. (Default value) System The system will not boot and will not access to Setup page if the correct password is not entered at the prompt. Please note that this feature is only working for operating system with multi processors mode supported. (Default value) CPU Hyper-Threading Disabled Enabled Init Display First Select the first initation of the monitor display from AGP or PCI VGA card. (Default value) 8S661FXM-RZ Motherboard - 26 - Integrated Peripherals CMOS Setup Utility-Copyright (C) 1984-2004 Award Software Integrated Peripherals IDE1 Conductor Cable IDE2 Conductor Cable On-Chip Primary PCI IDE On-Chip Secondary PCI IDE AC97 Audio Onboard LAN device USB Controller USB Legacy Support Onboard Serial Port 1 Onboard Serial Port 2 Onboard Parallel Port Parallel Port Mode ECP Mode Use DMA Game Port Address Midi Port Address x Midi Port IRQ [Auto] [Auto] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] [Disabled] [3F8/IRQ4] [2F8/IRQ3] [378/IRQ7] [ECP] [3] [201] [Disabled] [10] Item Help Menu Level u [Auto] Auto-detect IDE cable type [ATA66/100/133] Set Conductor cable to ATA66/100/133 (80 pins) [ATA33] Set Conductor cable to ATA33(40 pins) English higf: Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Save Defaults ESC: Exit F1: General Help F7: Optimized Defaults IDE1 Conductor Cable Auto ATA66/100/133 ATA33 BIOS autodetects IDE1 conductor cable . (Default Value) Set IDE1 Conductor Cable to ATA66/100/133 (Please make sure your IDE device and cable is compatible with ATA66/100/133). [. . . ] Please also note that Microsoft® USB2. 0 driver is currently supported by Windows XP and Windows 2000 only. Once we get the latest SiS® USB2. 0 driver for Windows 98 and Windows ME, we will put the driver on GIGABYTE website asap. (http://www. gigabyte. com. tw). For USB2. 0 driver support under Windows XP operating system, please use Windows Service Pack. After install Windows Service Pack, it will show a question mark "?" in "Universal Serial Bus controller" under "Device Manager". [. . . ]