User manual GIGABYTE GA-6VTXE

[. . . ] FCC Compliance Statement: This equipment has been tested and found to comply with limits for a Class B digital device , pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Most use for this area is Shadow RAM Extended Memory 38 6VTXE Motherboard BIOS Features Setup AMIBIOS SETUP ­ BIOS FEATURES CMOS SETUP ( C ) 1999 American Megatrends, Inc. All Rights Reserved 1st Boot Device 2nd Boot Device 3rd Boot Device S. M. A. R. T for Hard Disks IDE Boot Delay BootUp Num-Lock Floppy Drive Seek Password Check Processor Serial Number :Floppy :IDE-0 :CDROM :Disabled :Disabled :On :Disabled :Setup :Disabled ESC : Quit : Select Item F1 : Help PU/PD/+/- : Modify F5 : Old Values (Shift)F2 :Color F6 : Load Fail-Safe Defaults F7 : Load Optimized Defaults Figure 3: BIOS Features Setup · 1st / 2nd / 3rd Boot Device The default value is Floppy or LS-120 / ZIP A: or ATAPI ZIP C: or CDROM or SCSI or NET WORK / I20 or IDE-0~IDE-3 or Disabled. Floppy LS / ZIP A: CDROM SCSI NETWORK IDE-0~IDE-3 Disabled ATAPI ZIP C: Boot Device by Floppy. Boot Device by ATAPI ZIP C:. 39 BIOS Setup · S. M. A. R. T. for Hard Disks Enable Disable Enable S. M. A. R. T. (Default Value) · IDE Boot Delay Disabled 1 sec~10 sec Disable IDE boot delay time. (Default Value) Set IDE boot delay from 1 sec to 10 sec. · Boot Up Num-Lock On Off Keypad is number keys. (Default Value) Keypad is arrow keys. · Floppy Drive Seek During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks. 360 type is 40 tracks while 720 , 1. 2 and 1. 44 are all 80 tracks. Enabled BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks. Note that BIOS can not tell from 720, 1. 2 or 1. 44 drive type as they are all 80 tracks. BIOS will not search for the type of floppy disk drive by track number. Note that there will not be any warning message if the drive installed is 360. (Default Value) Disabled · Password Check Setup Always Set Password Check to Setup. (Default Value) Set Password Check to Always. · Processor Serial Number Disabled Enabled Disabled CPU Serial Number. (Default Value) Enabled CPU Serial Number. 40 6VTXE Motherboard Chipset Features Setup AMIBIOS SETUP ­CHIPSET FEATURE CMOS SETUP ( C ) 1999 American Megatrends, Inc. All Rights Reserved *** DRAM Timing *** Top Performance SDRAM Timing by SPD SDRAM CAS# Latency DRAM Frequency C2P Concurrency & Master DRAM Integrity Mode AGP Mode AGP Comp. Driving AGP Aperture Size USB Controller USB Legacy Support :Disabled :Disabled :3 :Auto :Enabled :Disabled :4X :Auto :CB :64MB :Enabled :Disabled ESC : Quit : Select Item F1 : Help PU/PD/+/- : Modify F5 : Old Values (Shift)F2 :Color F6 : Load Fail-Safe Defaults F7 : Load Optimized Defaults Figure 4: Chipset Features Setup · Top Performance Disabled Enabled Set Top Performance is disabled. (Default Value) Set Top Performance is enabled. · SDRAM Timing by SPD Disabled Enabled SDRAM Timing by SPD Function Disabled. (Default Value) SDRAM Timing by SPD Function Enabled. · SDRAM CAS# Latency 3 2 For Slower SDRAM DIMM module. (Default Value) For Fastest SDRAM DIMM module. · DRAM Frequency Auto 100MHz 66MHz 133MHz Set DRAM Frequency automation. (Default Value) Set DRAM Frequency is 100MHz. [. . . ] (°C / °F) ° Detect System Temperature automatically. 54 6VTXE Motherboard · Current CPU FAN Speed Detect CPU Fan speed status automatically . · Current System FAN Speed Detect System Fan speed status automatically . · Current Voltage (V) VCORE / +3. 3V / +12V / +5V Detect system's voltage status automatically. 55 BIOS Setup Set Supervisor / User Password When you select this function, the following message will appear at the center of the screen to assist you in creating a password. AMIBIOS SIMPLE SETUP UTILITY-VERSION 1. 24e ( C ) 1999 American Megatrends, Inc. All Rights Reserved STANDARD CMOS SETUP BIOS FEATURES SETUP CHIPSET FEATURES SETUP POWER MANAGEMENT SETUP INTEGRATED PERIPHERALS HARDWARE MONITOR & MISC SETUP SUPERVISOR PASSWORD USER PASSWORD PNP/PCI CONFIGURATION IDE HDD AUTO DETECTION Enter new supervisor password: LOAD Fail-Safe DEFAULTS LOAD Optimized DEFAULTS SAVE & EXIT SETUP EXIT WITHOUT SAVING F5 : Old Values F10: Save & Exit ESC : Quit : Select Item (Shift) F2 : Change Color F6 : Load Fail-Safe Defaults F7: Load Optimized Defaults Chang /Set /Disabled Password Figure 11: Password Setting Type the password, up to six characters, and press <Enter>. The password typed now will clear the previously entered password from CMOS memory. You will be asked to confirm the password. [. . . ]