User manual GIGABYTE GA-6VXC7-4X-P

[. . . ] FCC Compliance Statement: This equipment has been tested and found to comply with limits for a Class B digital device , pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] (Default Value) Keypad is arrow keys. · Floppy Drive Seek During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks. 360 type is 40 tracks while 720 , 1. 2 and 1. 44 are all 80 tracks. Enabled BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks. Note that BIOS can not tell from 720, 1. 2 or 1. 44 drive type as they are all 80 tracks. BIOS will not search for the type of floppy disk drive by track number. Note that there will not be any warning message if the drive installed is 360. (Default Value) Disabled · Password Check Setup Always Set Password Check to Setup. (Default Value) Set Password Check to Always. · Processor Serial Number Disabled Enabled Disabled CPU Serial Number. (Default Value) Enabled CPU Serial Number. 36 6VXC7-4X-P Motherboard Chipset Features Setup AMIBIOS SETUP ­CHIPSET FEATURE CMOS SETUP ( C ) 1999 American Megatrends, Inc. All Rights Reserved *** DRAM Timing *** Top Performance SDRAM Timing by SPD SDRAM CAS# Latency DRAM Frequency C2P Concurrency & Master DRAM Integrity Mode AGP Mode AGP Comp. Driving AGP Aperture Size ClkGen Spread Spectrum USB Controller USB Legacy Support :Disabled :Disabled :3 :Auto :Enabled :Disabled :4X :Auto :CB :64MB :Center±0. 25% :Enabled :Disabled ESC : Quit : Select Item F1 : Help PU/PD/+/- : Modify F5 : Old Values (Shift)F2 :Color F6 : Load BIOS Defaults F7 : Load Setup Defaults Figure 4: Chipset Features Setup · Top Performance Disabled Enabled Set Top Performance is disabled. (Default Value) Set Top Performance is enabled. · SDRAM Timing by SPD Disabled Enabled SDRAM Timing by SPD Function Disabled. (Default Value) SDRAM Timing by SPD Function Enabled. · SDRAM CAS# Latency 3 2 For Slower SDRAM DIMM module. (Default Value) For Fastest SDRAM DIMM module. · DRAM Frequency Auto 100MHz 66MHz 133MHz Set DRAM Frequency automation. (Default Value) Set DRAM Frequency is 100MHz. Set DRAM Frequency is 133MHz. 37 BIOS Setup · C2P Concurrency & Master Enabled Disabled Enabled C2P Concurrency & Master. (Default Value) Disabled C2P Concurrency & Master. · DRAM Integrity Mode ECC Disabled For 72 bit ECC type DIMM Model. (Default Value) · AGP Mode 4X 1X 2X Set AGP Mode is 4X. Set AGP Mode is 2X. · AGP Comp. Driving : 00~FF · AGP Aperture Size 4MB 8MB 16MB 32MB 64MB 128MB 256MB Set AGP Aperture Size to 4MB. (Default Value) Set AGP Aperture Size to 128 MB. Set AGP Aperture Size to 256 MB. · ClkGen Spread Spectrum Center ±0. 25% Center ±0. 5% Disabled Set ClkGen Spread Spectrum 0. 25%. (Default Value) Set ClkGen Spread Spectrum 0. 5%. [. . . ] To disable password, just press <Enter> when you are prompted to enter password. A message "PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is disabled, the system will boot and you can enter Setup freely. If you select "Always" at "Password Check" Option in BIOS Features Setup Menu, you will be prompted for the password every time the system is rebooted or any time you try to enter Setup Menu. [. . . ]